Marques

No brand

Fournisseurs

Référence: 92/91

Flanged ballrace 6 x 10 x 3 mm

Commentaire(s): 0

Ballraces are used wherever moving parts are required to run with a minimum of play and a minimum of friction. The more ballraces are used, the more smoothly the mechanics of a helicopter works, and the lower the rate of wear. The dimensions of a ballrace mean: inside diameter (I.D.) x outside diameter (O.D.) x thickness. For flanged bearings the same...

Prix 12,80 €
Détails
En vente sur demande
Toutes les meilleures ventes

Axe porte-pales 8 x 115,9 mm

73/15
Note 


 

  • Thrust bearing shaft
  • 8 Ø x 115.9 mm
23,80 €
TTC
Quantité
En vente sur demande

 

Política de seguridad

 

Política de envío

 

Política de devolución

Description


 

  • Thrust bearing shaft
  • 8 Ø x 115.9 mm
Détails du produit
73/15
Avis

Aucun avis n'a été publié pour le moment.

Donnez votre avis

Axe porte-pales 8 x 115,9 mm

Axe porte-pales 8 x 115,9 mm


 

  • Thrust bearing shaft
  • 8 Ø x 115.9 mm
Donnez votre avis
16 autres produits dans la même catégorie :

Référence: 78/41

Mixer lever cranked

Commentaire(s): 0

Mixer lever, content of the package 1 piece.Additionial accessories for the use of mixer levers are either two flanged ballraces or two flanged bushes from Delrin as a low cost alternative. The screwing on the blade holder arm complies with the kind of hole, i.e. it depends on the through hole or on the blind hole. Please note for choosing the screws:...

Prix 14,80 €
Détails
En vente sur demande

Référence: 72/3

Rotor brake, GRP, red

Commentaire(s): 0

When you have landed and stopped the engine, the rotor head continues spinning for quite some time until it stops by itself. A rotor brake shortens the time you have to wait. Using light pressure with the flat of your hand on the domed face of the rotor brake you can stop the rotor in a few moments.Please note: stay in safe distance away from the turning...

Prix 9,70 €
Détails
En vente sur demande

Référence: 76/16

GRP blade holder, 5 mm ∅ hole

Commentaire(s): 0

As demands on helicopters continue to rise, so stronger blade holders are required. In this case a 14 mm blade holder is combined with a 5 mm Ø hole for blade retention, i.e. the matching blade holder screws and self-locking nuts are M5 in size.GRP blade holder with long linkage armfor two-blade rotor heads

Prix 26,60 €
Détails
En vente sur demande

Référence: 54/13

Clamp ring pitch compensator 10 mm

Commentaire(s): 0

On longer rotor shafts the clamp ring for the pitch compensator sits underneath of the centre piece directly on the rotor shaft.Clamp ring for pitch compensator 10 mm Ø, length of the pin 30 mm.

Prix 23,80 €
Détails
En vente sur demande

Suivez-nous sur Facebook