Side frame right

Riferimento: 94/12

Bush 5 x 6 x 14 mm

Pack of 2

Riferimento: 54/6

Annular clamp ring / speed sensor

When you use a speed regulator you put the magnets into the cut-outs of this clamp ring. Clamp ring for speed collection, 10 mm Ø.

Riferimento: 36/48

Steel internal tooth gear

Steel internal tooth gear with matching clutch bellexternal diameter: 59 mmfor 10 mm shaft

Riferimento: 330/15

Bush 5 x 7 x 3.7 mm

Pack of 2

Riferimento: 57/2

Bush 3.1 x 10 x 4 mm

Pack of 2

Riferimento: 607/53

Set plato ciclico BO 105 T-Rex

Riferimento: 132/37

Montaggio dell'albero di trasmissione del rotore di coda, parte I

These parts are used in a petrol Fenestron mechanical system for mounting the gearbox, where the rotational speed of the tail drive shaft has to be increased.Pack of 2

Riferimento: 44/5

Boccola per rotore di coda azionato

Bush, hardened.

Riferimento: 15/7

Eje intermedio

Riferimento: 57/20

Pitch-axis crank set

 Content of the packagecomplete as shown

Riferimento: 307/53

Dome fittings set Lama T-Rex 700E

Swashplate / driver / mast lock / plus rods needed for fitting the 3 blade rotor head on the Lama with T-Rex 700E mechanics

Riferimento: 49/16

Retaining spring

If your helicopter accidentally makes ground contact, the claw coupling may disengage, and the cruciform element may be lost. Fitting an annular retaining spring ensures exact alignment of the claw coupling, and prevents the cruciform element slipping out.  Retaining springpack of 2

Riferimento: 36/11

Bush 10 x 14 x 2.5 mm

The freewheel hubs are sealed on both sides by brass rings; the rings can also be replaced when necessary (i.e. when the freewheel bearings are replaced).Pack of 2

Riferimento: 36/40

Reinforced freewheel bell compl.

Provided that you maintain your model helicopter conscientiously and set it up according to the instructions, the model's flying load limits are well outside its normal flight envelope.Detail features of the kit are designed to suit normal applications, but different parts can be retro-fitted at any time, e.g. if you wish to convert a Kobold into a...

Riferimento: 870/200

R. H. conversion set X-Treme

For the conversion of a L.H. X-Treme trainer into a R.H. mechanics needed parts are assembled in this set. This set contains all the parts required for the conversion of a L.H. X-Treme trainer into R.H. mechanics.

Riferimento: 830/45

Mechanics frame strengthener

Mechanics frame strengthener.