Top gear support GRP

Référence: 722/49

Tube drive adapter for shaft 8 mm

Content of the package: 1 piece

Référence: 78 A

Douille 3,1 x 4 x 6,4 mm

Pack of 2

Référence: 607/53

Set plato ciclico BO 105 T-Rex

Référence: 36/40

Reinforced freewheel bell compl.

Provided that you maintain your model helicopter conscientiously and set it up according to the instructions, the model's flying load limits are well outside its normal flight envelope.Detail features of the kit are designed to suit normal applications, but different parts can be retro-fitted at any time, e.g. if you wish to convert a Kobold into a...

Référence: 54/9

Clamp ring 10 mm diameter rotor shaft

Below the dome plate you install the clamp ring with the socket on top if no thrust bearing is mounted. The socket supports the clamp ring against the inner ring of the ballrace - otherwise the clamp ring would grind on the outer ring, and affect the function of the ballrace.Clamp ring for rotor shaft, 10 mm diameter

Référence: 165

Collet 5 mm

Pack of 2 incl. screws

Référence: 64/69

Washer for crankshaft screw

 Content of the package1 piece

Référence: 36/11

Douille 10 x 14 x 2,5 mm

The freewheel hubs are sealed on both sides by brass rings; the rings can also be replaced when necessary (i.e. when the freewheel bearings are replaced).Pack of 2

Référence: 71/2

Douille 3 x 5 x 4,8 mm

Pack of 2

Référence: 49 B

Collet 2 mm

 Content of the package1 piece

Référence: 57 A

Douille 3 x 4 x 6,3 mm

Pack of 2

Référence: 412/53

Dome fittings set 4-blade T-Rex Bell 412

Not available

Référence: 36/4

Freewheel washer 5.9 x 11.9 mm

The freewheel disc is positioned on the spigot of the main rotor shaft, with the inner flange in contact with the inner ring of the ballrace in the main gearbox. If you install a driven tail rotor for auto-rotation, a second disc is fitted at the underside of the gearbox, to prevent friction of the rotating parts against the outer ring of the ballrace....

Référence: 54/6

Annular clamp ring / speed sensor

When you use a speed regulator you put the magnets into the cut-outs of this clamp ring. Clamp ring for speed collection, 10 mm Ø.

Référence: 7/36

Main shaft sleeve

 Content of the package1 piece

Référence: 500/362

Freewheel clockwise

Not available