Servo output arm for Futaba servos
14,80 €
TTC
Strong aluminium servo output arms with M 2.5 tapped holes offer the advantage of more precise control, as they do not flex in use. The maximum hole spacing from the centre of the servo output shaft to the outside pivot point is 21 mm.
They are exclusively designed to fit Futaba servos, but they do not fit servos with metal output gears.
The sets contain either four output arms without, or one output arm with ball end-bolt M 2.5 x 5.
- Servo output arm for Futaba servos
- pack of pack of 1
- with ball-end bolt 060/7
Strong aluminium servo output arms with M 2.5 tapped holes offer the advantage of more precise control, as they do not flex in use. The maximum hole spacing from the centre of the servo output shaft to the outside pivot point is 21 mm.
They are exclusively designed to fit Futaba servos, but they do not fit servos with metal output gears.
The sets contain either four output arms without, or one output arm with ball end-bolt M 2.5 x 5.
- Servo output arm for Futaba servos
- pack of pack of 1
- with ball-end bolt 060/7
3971
Commentaires (0)
Aucun avis n'a été publié pour le moment.
Strong aluminium servo output arms with M 2.5 tapped holes offer the advantage of more precise control, as they do not flex in use. The maximum hole spacing from the centre of the servo output shaft to the outside pivot point is 21 mm.
They are exclusively designed to fit Futaba servos, but they do not fit servos with metal output gears.
The sets contain either four output arms without, or one output arm with ball end-bolt M 2.5 x 5.
- Servo output arm for Futaba servos
- pack of pack of 1
- with ball-end bolt 060/7