Lampe 1:4

Riferimento: 341/405

Pitot 41:4

dimensions: 5.7 x 1.7 x 2.5 cm

Riferimento: 341/419

Tendicinghia pulegge, 6 pz Lama 1/4

1,18 x 3,15 x 0,72 cmPack of 6

Riferimento: 341/36

CESTELLO SOTTOPANCIA PER LAMA

Load basket for Lamalength:410 mmwidth:100 mmheight70 mm

Riferimento: 340/5

Snowboards per Lama 1 paio

When full-size helicopters have to land in deep snow, the skids are fitted with "snowboards" to prevent them sinking in.On the model they look really good, and also help the pilot detect the model's orientation in the air.Make your model an eye-catcher and use some rivets for the decoration of the skies."Snowboards" for Lama, 1 pair

Riferimento: 340/1

Supporti ruota per Lama

The Lama is a large helicopter, and the supplementary wheels which can be attached to the landing gear make it much easier to move the machine into and out of the hangar. However, the wheels are removed prior to flying the model. These wheel holders for our model of the Lama are made of plastic and are simply glued to the 20 mm Ø skid tubes using UHU...

Riferimento: 341/417

Specchio Grande, Lama 1:4

dimensions: 4 x 5.4 x 1 cm

Riferimento: 10/96

Anti-collision light with red housing

Riferimento: 341/408

Serbatoio Olio piccolo, Lama, 1:4

dimensions: 6.8 x 1.8 x 6.8 cm

Riferimento: 341/507

Serbatio olio grande Lama 1/4

dimensions: 5.15 x 3.62 x 5.1 cm

Riferimento: 341/424

Kick bar llama 2 partes 1: 4

Riferimento: 341/402

Filtro, Lama 1:4

dimensions: 4.3 x 2.5 cm, inner diameter: 1.43 cm

Riferimento: 341/508

Serbatio olio piccolo Lama 1/4

dimensions: 5.45 x 1.66 x 5.36 cm

Riferimento: 341/404

Luci di posizione Lama 1/4 , 2 pc

dimensions: 4.5 x 3.2 x 1.8 cmPack of 2 (l/r)

Riferimento: 341/415

Llamada de rescate por radar x2 1: 4

Riferimento: 350/45

CESTELLO SOTTOPANCIA PER LAMA

Great fascination is achieved by active working details on scale models, remember e.g. rotary lights and navigation lights.A working winch adds a special attraction on a model helicopter particularly if it is pivoting and fully functional!Especially on a Alouette III you hardly need fantasy, to see instead of the model the full-size helicopter in your...

Riferimento: 330/2

Imitazione turbina

The dummy turbine provides the ideal starting point if you wish to install additional scale fittings on your Lama.The dummy turbine is assembled from six separate GRP mouldings, and fits all models with VR-22 mechanics installed.In the turbine-powered version of the Lama the actual turbine is located in this position.GRP dummy turbineLength approx. 490 mm