Vario catalogue 2017
Référence: 2017 E
Lama / Alouette II 1:4
Les manches à balai et le levier de Pas font partie des équipements de base de chaque cockpit.La version illustrée correspond à ceux utilisés dans l'hélicoptère grandeur Schweizer 300 C....
Load basket for Lamalength:410 mmwidth:100 mmheight70 mm
dimensions: 10.63 x 0.7 x 1.3 cmPack of 2, each 2-part
The hook for the Lama is fully functional. The scale aluminium frame comes with further more accessories, inclusive servo mount.The fuselage already offers the fastening, ready soldered.On your model you mount the hook in the required location, and release dummy loads by activating a servo via your transmitter.
dimensions: main part: 9.5 x 4.95 x 6.4 cm6-part
dimensions: diameter: 1.1 cm, length: 5.7 cm
The suckering ducts are on the model exactly on the same place as the original ones in position to the turbine on the full-size helicopter.
As you would expect, we can also supply the matching type of GRP helmet for William the Pilot; it is simply pushed into place on his head. If you wish to fit a radio headpiece, you now have plenty of scope for your imagination: a piece of foam rubber, a thin wire mount and a coiled cable are all you need to make this accessory, and the pilot will...
The dummy turbine provides the ideal starting point if you wish to install additional scale fittings on your Lama.The dummy turbine is assembled from six separate GRP mouldings, and fits all models with VR-22 mechanics installed.In the turbine-powered version of the Lama the actual turbine is located in this position.GRP dummy turbineLength approx. 490 mm
dimensions: 4.3 x 2.5 cm, inner diameter: 1.43 cm
dimensions: 5.45 x 1.66 x 5.36 cm
When full-size helicopters have to land in deep snow, the skids are fitted with "snowboards" to prevent them sinking in.On the model they look really good, and also help the pilot detect the model's orientation in the air.Make your model an eye-catcher and use some rivets for the decoration of the skies."Snowboards" for Lama, 1 pair