Trappe kero Lama N1 1:4

Riferimento: 341/417

Specchio Grande, Lama 1:4

dimensions: 4 x 5.4 x 1 cm

Riferimento: 340/29

Cockpit for Lama, turbine version

Riferimento: 340/6

Pedana di salita per Lama

If you have a mind to continue adding detail fittings to your Lama, you are sure to appreciate this landing gear step which can be fitted to an existing model at any time. The step is made of stainless steel, and is supplied complete with clips, screw fittings and tread material. Entry step, for Lama, pack of 1

Riferimento: 330/10

Protezione capottina per Lama

This protective sheath provides effective protection to the cabin of your valuable helicopter, and helps to avoid unsightly scratches. It is simply pulled over the cabin and closed with a hook -and-loop fastener.Cabin sheath for Lamamatching the cabins of the models 3300 and 3400

Riferimento: 341/414

Lama 1: 4 luz anticolisión trasera

Riferimento: 341/413

Wiper, 1:4,2

dimensions: 10.63 x 0.7 x 1.3 cmPack of 2, each 2-part

Riferimento: 330/2

Imitazione turbina

The dummy turbine provides the ideal starting point if you wish to install additional scale fittings on your Lama.The dummy turbine is assembled from six separate GRP mouldings, and fits all models with VR-22 mechanics installed.In the turbine-powered version of the Lama the actual turbine is located in this position.GRP dummy turbineLength approx. 490 mm

Riferimento: 341/415

Llamada de rescate por radar x2 1: 4

Riferimento: 341/424

Kick bar llama 2 partes 1: 4

Riferimento: 341/408

Serbatoio Olio piccolo, Lama, 1:4

dimensions: 6.8 x 1.8 x 6.8 cm

Riferimento: 340/2

Accessori per Lama turbina

The suckering ducts are on the model exactly on the same place as the original ones in position to the turbine on the full-size helicopter.

Riferimento: 340/1

Supporti ruota per Lama

The Lama is a large helicopter, and the supplementary wheels which can be attached to the landing gear make it much easier to move the machine into and out of the hangar. However, the wheels are removed prior to flying the model. These wheel holders for our model of the Lama are made of plastic and are simply glued to the 20 mm Ø skid tubes using UHU...

Riferimento: 341/507

Serbatio olio grande Lama 1/4

dimensions: 5.15 x 3.62 x 5.1 cm

Riferimento: 341/36

CESTELLO SOTTOPANCIA PER LAMA

Load basket for Lamalength:410 mmwidth:100 mmheight70 mm

Riferimento: 341/404

Luci di posizione Lama 1/4 , 2 pc

dimensions: 4.5 x 3.2 x 1.8 cmPack of 2 (l/r)

Riferimento: 330/31

Finestratura a boccia, Lama

Bubble window for Lama Ord.No. 3300 / 3400 / 3401, Rotor ø 2500 mm