Entrée l'air turbine 1:4

Riferimento: 134/410

Antena superior 1: 4

Riferimento: 341/414

Lama 1: 4 luz anticolisión trasera

Riferimento: 341/404

Luci di posizione Lama 1/4 , 2 pc

dimensions: 4.5 x 3.2 x 1.8 cmPack of 2 (l/r)

Riferimento: 134/444

Connessioni verricello, 1:4

dimensions:flat: 1.53 x 1.53 x 0.7 cmhigh: 1.29 x 1.29 x 1.14 cmPackage contains: 3x flat + 4x high

Riferimento: 341/403

Per Lama, 1:4

dimensions: 6 x 8.2 x 0.5 cm2-part

Riferimento: 341/417

Specchio Grande, Lama 1:4

dimensions: 4 x 5.4 x 1 cm

Riferimento: 341/406

Scatola Fusibili Electric Box Lama 1:4

dimensions: 12.6 x 7 x 4.3 cm2-part

Riferimento: 134/455

Torch dummy 1:4

dimensions: diameter: 1.1 cm, length: 5.7 cm

Riferimento: 341/424

Kick bar llama 2 partes 1: 4

Riferimento: 340/1

Supporti ruota per Lama

The Lama is a large helicopter, and the supplementary wheels which can be attached to the landing gear make it much easier to move the machine into and out of the hangar. However, the wheels are removed prior to flying the model. These wheel holders for our model of the Lama are made of plastic and are simply glued to the 20 mm Ø skid tubes using UHU...

Riferimento: 340/29

Cockpit for Lama, turbine version

Riferimento: 341/407

Serbatio Olio, Lama, 1:4

dimensions: 6.5 x 4.5 x 6.,5 cm2-part

Riferimento: 341/429

Pannello Cockpit dettagliato, LAMA

Addition to the Cockpit Ord. No. 340/29 to make it look more realistic

Riferimento: 1/21

Helmet for pilot William

As you would expect, we can also supply the matching type of GRP helmet for William the Pilot; it is simply pushed into place on his head. If you wish to fit a radio headpiece, you now have plenty of scope for your imagination: a piece of foam rubber, a thin wire mount and a coiled cable are all you need to make this accessory, and the pilot will...

Riferimento: 330/2

Imitazione turbina

The dummy turbine provides the ideal starting point if you wish to install additional scale fittings on your Lama.The dummy turbine is assembled from six separate GRP mouldings, and fits all models with VR-22 mechanics installed.In the turbine-powered version of the Lama the actual turbine is located in this position.GRP dummy turbineLength approx. 490 mm

Riferimento: 330/45

Gancio carico

The hook for the Lama is fully functional. The scale aluminium frame comes with further more accessories, inclusive servo mount.The fuselage already offers the fastening, ready soldered.On your model you mount the hook in the required location, and release dummy loads by activating a servo via your transmitter.