Filtra per

Disponibilità

Disponibilità

Prezzo

Prezzo

  • 5,00 € - 137,00 €

Categorie

Categorie

Marchi

Nessuna marca

Fornitori

Riferimento: 92/91

Flanged ballrace 6 x 10 x 3 mm

Recensioni: 0

Ballraces are used wherever moving parts are required to run with a minimum of play and a minimum of friction. The more ballraces are used, the more smoothly the mechanics of a helicopter works, and the lower the rate of wear. The dimensions of a ballrace mean: inside diameter (I.D.) x outside diameter (O.D.) x thickness. For flanged bearings the same...

Prezzo 14,70 €
Più
In vendita su richiesta

Riferimento: 70/76

Aste 3,0 x 75 mm

Recensioni: 0

Ready-made pushrod, threaded M 3. Content of the package: 1 piece

Prezzo 6,30 €
Più
In vendita su richiesta
Tutte le migliori vendite

Ci sono 53 prodotti.

Visualizzati 25-36 su 53 articoli

Filtri attivi

  • Categorie: Attrezzatura specifica
  • Categorie: Files, Perma Grit

Riferimento: 11/56

Glasspaper file, concave / convex

Recensioni: 0

If you enjoy building full-fuselage models you cannot help but appreciate practical tools which make your work easier. The glasspaper file is ideal for final trimming of openings for windows, doors and vent grilles after machining them out. The file is 25 cm long overall, with a sanding area 13 cm long and 2.5 cm wide on each side. The file is supplied...

Prezzo 12,80 €
Più
In vendita su richiesta

Riferimento: 11/60

Tubing cutter, up to 15 mm Ø

Recensioni: 0

The tubing cutter can handle aluminium, stainless steel and brass tubing up to 15 mm diameter. It can also be used to form a slight internal burr on tubing. For example if you use a tail rotor pushrod running in a PTFE sleeve in aluminium tubing, you can cut the aluminium to length at both ends with the tubing cutter, and the PTFE sleeve will not slip out.

Prezzo 33,30 €
Più
In vendita su richiesta

Riferimento: 11/64

Hole cutter up to 16 mm Ø

Recensioni: 0

There are far more holes to be drilled in a helicopter fuselage than just the ordinary air inlet holes. Think of the access holes for the needle valve and the glow plug, openings for the exhaust manifold and the initial stage of cutting window openings. This hole cutter does an excellent job. Hole cutter, up to 16 mm. Here a few hints for making perfect...

Prezzo 54,60 €
Più
In vendita su richiesta

Riferimento: 11/65

Soft sanding paper

Recensioni: 0

For preparing the GRP surface prior to the paintingP400dimensions: 11.5 x 15 cmPack of 5

Prezzo 9,70 €
Più
In vendita su richiesta

Riferimento: 11/80

Pipe bending tool

Recensioni: 0

A versatile bending tool for fuel tank pipes, dummy collective pitch sticks in the cockpit etc. The tool is useful for tubes or pushrods with a diameter of 3.0 and 3.2 mm

Prezzo 44,30 €
Più
In vendita su richiesta

Seguici su Facebook