Staffa angolare

Référence: 810/5

Kufenauflage

Référence: 260/38

Tirant pour moteur

Strut for motor, XLV.

Référence: 800/20

Béquille rouge

Tail skids only. Create your own individual colour scheme: e.g. white stabiliser - red skid!

Référence: 260/2

Support de empennage et tirants

Tail fin and strut holder XLV.

Référence: 830/10

Streben für Benzin-Trainer

Référence: 260/5

Support de stabilisateur

Boom clamp for stabilizer, turbine version XLV.

Référence: 107/28

Raccord articulé droit

 Ball-linkstraightpack of 6

Référence: 800/25

Kit empennage, grand

If you fit a large stabiliser to your trainer there is no need for a tail skid. This stabiliser provides the tail rotor blades with enough ground clearance, and offers good flight stability at low airspeeds. There are two versions with different methods of attachment.275 mm high118 g total weightscrew fitting to tail rotor holder

Référence: 800/21

Béquille jaune

Tail skids only. Create your own individual colour scheme: e.g. white stabiliser - red skid!

Référence: 107/26

Kit tringles pour X-Treme

Chassis brace set for X-Treme31-part

Référence: 830/6

RC-Vorbau

Référence: 800/50

Empennage 3-D en fibre de carbone

When you are attempting high-speed flying in reverse and also certain pirouettes you may find that the helicopter's heading changes due to the influence of the solid vertical stabiliser. That is the basic reason for the development of this special 3-D tail.It is very strong, and its large size removes the need for a tail skid. The stabiliser is...

Référence: 800/4

Kit empennage blanc

Instead of a horizontal fin (for mounting on the tail boom) the small inset horizontal panel replaces that. The inset fits on top of the stabiliser, outwards opposite of the tail rotor.220 mm high, excl. tail skid3-part, 45 g total weight

Référence: 860/11

Heckrohrhalter, 2fach kugelgelagert

Référence: 260/7

Support de poutre

Tail boom holder XLV.

Référence: 890/49

Lagerplatte