Verbreiterungs-Set

Référence: 809/6

RC-Vorbau Sky Fox

Référence: 722/39

Tirant pour moteur

Support for motor

Référence: 800/36

Bouchon en caoutchouc 14 mm, pin 5x6mm

Rubber plug 14 mmCone 5 x 6 mmContent of the package 6 pieces

Référence: 830/10

Streben für Benzin-Trainer

Référence: 809/24

Kühlluftschacht Skyfox, rauchglas

Référence: 890/49

Lagerplatte

Référence: 260/11

Kit empennage XLV Trainer

GRP Stabiliser set for XLV Trainer.

Référence: 809/12

M 4 Verschraubung

Référence: 860/120

Toothed belt for X-Perience, 3M/606

Toothed belt for X-Perience. Content of the package: 1 piece.

Référence: 860/11

Heckrohrhalter, 2fach kugelgelagert

Référence: 860/30

CFK-Rohr 8 x 6 x 700 mm

Référence: 800/25

Kit empennage, grand

If you fit a large stabiliser to your trainer there is no need for a tail skid. This stabiliser provides the tail rotor blades with enough ground clearance, and offers good flight stability at low airspeeds. There are two versions with different methods of attachment.275 mm high118 g total weightscrew fitting to tail rotor holder

Référence: 800/37

Support de verrière 26 mm

The required length of the canopy holder is determined by the kind of canopy and the location of its fitting points on the side frames.

Référence: 310/8

Support de résonateur 70 mm

GRP tuned pipe holders are used to secure the tuned pipe to the tail booms. They are easy to clamp in place. The tail pipe of the tuned pipe should be covered with silicone hose (Order No. 116/8), or with one of the tail pipes (Ord.No. 116/0 or 116/9), so that the heat of the pipe does not damage the holder.Tuned pipe holder, 2-partfor 20 mm ��tail boom

Référence: 802/17

Support de tirants - 25mm

  Content of the package 1 piece

Référence: 800/5

Kit empennage rouge

Instead of a horizontal fin (for mounting on the tail boom) the small inset horizontal panel replaces that. The inset fits on top of the stabiliser, outwards opposite of the tail rotor.220 mm high, excl. tail skid3-part, 45 g total weight