Mechanics support, rear

Référence: 102

Douille 3 x 5 x 2,6 mm

Pack of 2

Référence: 36/42

Freewheel hub for 36/43

 Content of the package1 piece "with" internal tooth gear

Référence: 53/7

dome extension 49 mm

aluminum

Référence: 870/20

Circlip for 8 mm diameter shaft

 Circlip for 8 mm Ø shaftpack of 2

Référence: 330/15

Bush 5 x 7 x 3.7 mm

Pack of 2

Référence: 722/38

Motor mount

Motor mount

Référence: 722/53

dome extension 109 mm

aluminum

Référence: 607/53

Set plato ciclico BO 105 T-Rex

Référence: 870/200

R. H. conversion set X-Treme

For the conversion of a L.H. X-Treme trainer into a R.H. mechanics needed parts are assembled in this set. This set contains all the parts required for the conversion of a L.H. X-Treme trainer into R.H. mechanics.

Référence: 251/15

Lay shaft 8 x 191 mm

 Lay shaft for X-Treme8 x 191 mm

Référence: 94/11

Bush 5 x 8 x 2.5 mm

Pack of 2

Référence: 266/31

Blue anodized hub gear

Not available

Référence: 834/51

CFK Side frame for Benzin Acrobatic

Not available

Référence: 132/37

Fixation pièce I pour transmission

These parts are used in a petrol Fenestron mechanical system for mounting the gearbox, where the rotational speed of the tail drive shaft has to be increased.Pack of 2

Référence: 54/14

Clamp ring 12 mm for rotor shaft

The clamp ring below the dome plate secures the rotor shaft inside the mechanics. Pay attention to achieve a safe installation, because the complete model is hanging on this clamp ring! Clamp ring for rotor shaft 12 mm Ø

Référence: 47/11

Spacer 8 x 16 x 5 mm

 Content of the package1 piece