

Ninguna marca
Referencia: 34/38
Palas del rotor de cola Juego de 2 palaslongitud = 130 mmancho = 35 mm13 gsimétricopara portacuchillas con portacuchillas de 5 mm (¡no para portacuchillas Vario!), 1 orificio, Ø 3 mmcompatible con NHP
Política de seguridad
Política de envío
Política de devolución
No hay reseñas de clientes en este momento.
Reference: 107/43
Chrome-plated brass balls are used to screw onto bell cranks or servo arms for connection to the ball-links of pushrods. The chromium plating prevents premature wear of the ball links.Content of the package: 10 pieces.
Reference: 49/55
This slotted connection shaft holds the loop of the 2 mm tail drive wire. Like all other tail drive systems it is necessary to install "play" (approx. 1 mm) for the wire. Yoke connector5 mm diameter shaft
Reference: 53
At the top of the mechanics the dome plate supports the rotor shaft with the help of a 10 x 21 x 5 mm or 12 x 21 x 5 mm ballrace. To reduce the load on the ballrace a thrust bearing can also be fitted under the dome plate.
Reference: 53/15
Bell cranks/main shaft adaptor for JetCat Turbine, for 2-blade main rotor head
Reference: 834/50
The outstanding features of the BENZIN Acrobatic models are mainly based on these side frames. The engine moved to the front to optimise the CofG.Installation of an on-board electric starter as an option.CCPM - i.e. direct linkage at 4-points / 90 degreeInstallation of the tank below the main rotor shaft, i.e. while the tank runs dry the CofG does not...
Reference: 44/7
Freewheel hub, 10 mm diameter freewheel
Reference: 49/16
If your helicopter accidentally makes ground contact, the claw coupling may disengage, and the cruciform element may be lost. Fitting an annular retaining spring ensures exact alignment of the claw coupling, and prevents the cruciform element slipping out. Retaining springpack of 2
Reference: 53/19
Dome fittings set for JetCat PHT3-L turbine