Rotor blade support

Riferimento: 1414

Battery Switch

Dual power supply with gas cap switch

Riferimento: 17/2

Steel guide 6.2 x 10 mm

Content of the package 1 piece

Riferimento: 17/4

GRP bracket

 Content of the package1 piece

Riferimento: 18/12

Aluminium tube 4.0 x 3.0 x 1000 mm

Aluminium tube 4.0 x 3.0 x 1000 mm

Riferimento: 3941

Servo plug lead

Servo plug leadplug for JR

Riferimento: 33/6

Rotor blade pouch 2x3 blade max Ø 2100 mm

Riferimento: 1413

Electronic switch harness

Not available

Riferimento: 603/40

Al plate, mechanics bearer Schweizer 300 C

Component part for fuselages, Ord.No. 6030 or 6031.

Riferimento: 74

O-ring 3 x 8 mm hard

O-ring 3 x 8 mm hard Content of the package: 4 pieces Tip: O-rings always slide with a drop of silicone oil onto the shaft.

Riferimento: 18/10

PTFE tube for tail drive shaft

PTFE is used as a bearing for the 2 mm wire tail drive shaft (Ord.No. 17) or as a support guide for the 2 mm piano wire push rod (Ord.No. 21 and 800/12) Length: approx. 740 mm

Riferimento: 305/18

Halter Kugellager

Riferimento: 18/1

PVC tube 3.0 x 2.0 x 980 mm, red

PVC tube 3.0 x 2.0 x 980 mm, red

Riferimento: 33/66

Rotor blade pouch 2x3 blade max Ø 2500 mm

Riferimento: 3936/1

Y-lead

If you want to operate two servos in parallel from one receiver channel you requires a Y-lead.

Riferimento: 10/75

Glue dispenser

When you insert cartridges Ord.No. 10/73 into the dispenser and press the components through the mixing nozzle the epoxy is ready for immediate use.

Riferimento: 13/21

Magnets for speed regulator

These magnets are suitable for use with all commercial speed regulators. For installation in the mechanics it is advisable the magnets be glued in a clamp ring Ord.No. 54/6, or as in the photo on the internal-tooth gear ring. Pack of 3