Heckrohrhalter

Riferimento: 800/36

Tappo di gomma di 14 mm, pin 5x6mm

Rubber plug 14 mmCone 5 x 6 mmContent of the package 6 pieces

Riferimento: 7/10

Asole per sala riunioni 3 x

 Content of the package2 pieces

Riferimento: 800/23

Morsetto per stabilizzatore orizzontale 800/25

Component part for stabiliser set, Ord.No. 800/25

Riferimento: 870/7

Heckrohrhalter, Alu

Riferimento: 800/50

Stabilizzare 3-D, fibra di carbonio

When you are attempting high-speed flying in reverse and also certain pirouettes you may find that the helicopter's heading changes due to the influence of the solid vertical stabiliser. That is the basic reason for the development of this special 3-D tail.It is very strong, and its large size removes the need for a tail skid. The stabiliser is...

Riferimento: 870/30

Streben-Set, CFK

Riferimento: 260/11

Set stabilizzatore, XLV

GRP Stabiliser set for XLV Trainer.

Riferimento: 24/7

Conducto de aire de enfriamiento para foxy

Riferimento: 800/25

Stabilizzatore grande

If you fit a large stabiliser to your trainer there is no need for a tail skid. This stabiliser provides the tail rotor blades with enough ground clearance, and offers good flight stability at low airspeeds. There are two versions with different methods of attachment.275 mm high118 g total weightscrew fitting to tail rotor holder

Riferimento: 800/37

Supporto per tettuccio da 26 mm

The required length of the canopy holder is determined by the kind of canopy and the location of its fitting points on the side frames.

Riferimento: 802/17

Supporto montante 25 mm

  Content of the package 1 piece

Riferimento: 870/31

Strebenanschluß-Hülse

Riferimento: 809/12

M 4 Verschraubung

Riferimento: 722/37

Staffa angolare

Angle bracket

Riferimento: 860/11

Heckrohrhalter, 2fach kugelgelagert

Riferimento: 7/57

70 mm M 3 estudios

 Content of the package1 piece