Exhaust tube for turbine, AIRWOLF, Bell 230 und Bell 430

Référence: 268/16

Exhaust for XL-C

Exhaust tubes for turbines are always designed for the specified model. It is important that no forward thrust emerges from the system. Should this still occur, the forward thrust produced is minimal.Turbine exhaust tubes are designed as exhaust-gas diffusers, i.e. opens wider towards the rear.

Référence: 770/16

Exhaust tube for turbine, BK 117

On the BK 117 the forward thrust is eliminated by the scale division of the exhaust tube (enlarging of the cross-section) and exhausting up through the rotor disc.

Référence: 641/16

Exhaust system for Air-Crane

right / leftThis exhaust system is designed for the Air-Crane with turbine power system.

Référence: 144/16

Exhaust for EC 145 Turbine

stainless steelfor turbine 

Référence: 340/16

Exhaust for Lama

This exhaust system is designed for the Lama with turbine power system.

Référence: 530/17

Tapa de escape Ø 55 mm

Référence: 344/16

Exhaust for "Starwood" Lama

Not available

Référence: 900/16

Exhaust, stainless steel

Exhaust, stainless steel, for Ecureuil

Référence: 520/16

Exhaust tube for turbine

The outlets on the left and right hand sides offer the necessary cross-section and greatly reduce the forward thrust.This keeps the scale rear outlet while only discharging a small amount of the total exhaust gas.

Référence: 9/26

Ceramic band 50x3x1000 mm

Not available

Référence: 429/16

Exhaust Bell 429

Stainless steel exhaust manufactured specifically for the Bell 429

Référence: 206/16

Exhaust for UH-1D

This exhaust system is designed for the UH-1D with turbine power system.Exhaust tubes for turbines are always designed for the specified model. It is important that no forward thrust emerges from the system. Should this still occur, the forward thrust produced is minimal.Turbine exhaust tubes are designed as exhaust-gas diffusers, i.e. opens wider towards...

Référence: 25/9

Heat reflective mat

Between fuselage and exhaust tube a heat-reflecting mat avoids melting of the fibreglass. Even in smaller fuselages where conventional silencer systems are close to the inside surface, the heat reflective mat is useful as a heat shield.Heat reflective matheat rejectingsize approx. 300 x 700 mmmat thickness approx. 3 mm

Référence: 791/16

Exhaust tube for turbine, Cobra

Exhaust tubes for turbines are always designed for the specified model. It is important that no forward thrust emerges from the system. Should this still occur, the forward thrust produced is minimal.Turbine exhaust tubes are designed as exhaust-gas diffusers, i.e. opens wider towards the rear.

Référence: 342/16

Exhaust for Gazelle

Not available

Référence: 530/16

Exhaust efflux for CH-53

right / left