GRP blade holder reinforced

Reference: 74/3

O-ring 1 x 4 mm soft

content of the package: 8 pieces

Reference: 707/3

Rotor head cover for 3-blade head

155 mm diameter

Reference: 72/10

Rotor head centre piece

Rotor head centre piece for 2-bladed rotor head.

Reference: 832/54

Clamp ring

Clamp ring for rotor head 722/72.

Reference: 703/72

Eje de rodamiento de cuchillas para cabezal de 3 cuchillas

Reference: 702/76

GRP blade holder, 22 mm blade throat

This blade holder was specially developed for the large Bell 47 G III with a rotor diameter of 2.36 m. It has a 22 mm blade throat and a 6 mm Ø bore for the retaining screw, i.e. the matching blade holder screws and self-locking nuts are M6 in size.

Reference: 74/7

Rotor head dampers for 2 blade FBL systems

Flybarless electronics have now become common. Where they are being used harder damping is required.For these cases Vario is now offering a harder damping of the blade shaft provided by a pretension absorbing element in the centre block.For the adjustment, the outer O-ring position can be selected between "hard" and "soft" flight characteristics.Important...

Reference: 72/3

Rotor brake, GRP, red

When you have landed and stopped the engine, the rotor head continues spinning for quite some time until it stops by itself. A rotor brake shortens the time you have to wait. Using light pressure with the flat of your hand on the domed face of the rotor brake you can stop the rotor in a few moments.Please note: stay in safe distance away from the turning...

Reference: 702/92

Rotor head balance weight Bell 47 black

Not available

Reference: 702/15

15mm 2 blade centre piece

Aluminium centre piece for 15 mm Ø main shaft

Reference: 82/50

Rocker, aluminium

Rocker, aluminium, for rotor head 702/75, alone.

Reference: 72/40

Rotor head centre piece

Aluminium centre piece for 10 mm main shaft

Reference: 10/91

Silicone sleeve 8 x 2 x 100 mm

Content of the package: 1 piece

Reference: 87/4

Double ball-link, 90°

A 90° twisted double ball-link connect the mixer lever to the ball collet on the flybar. Content of the package: 2 pieces

Reference: 72/50

Electro rotor head centre piece

Electro rotor head centre piece, alu.

Reference: 79/13

Flybar stainless steel 4 x 560 mm

The length of the flybar itself also plays an important role in the model's flight characteristics: the longer the flybar, the smoother the hover. A longer flybar increases the control deflections. 450 mm length is considered normal, while 510 mm provides more docile handling.