O-ring 2.5 x 13 mm soft

Référence: 71/4

Pièce centrale en alu Ø 10 mm

Pitch mixer centre piece, aluminium, 10 mm ∅

Référence: 68/19

Bearing pin

Bearing pin for swashplate driver 68/20. Content of the package: 1 piece.

Référence: 832/75

Thrust washer

Thrust washer for rotor head Content of the package: 2 pieces

Référence: 702/10

Piéce centrale élastomère

Elastomer 2-blade-centre piece, GRP.

Référence: 702/90

Aluminium centre piece

Aluminium centre piece for 12 mm Ø main shaft

Référence: 71/27

Goupille avec circlips

Pivot pin with circlipContent of the package 2 pieces

Référence: 832/74

Joint torique 9 x 4.5 mm

O-ring 9 x 4.5 mm Content of the package: 4 pieces Tip: O-rings always slide with a drop of silicone oil onto the shaft.

Référence: 702/92

Rotor head balance weight Bell 47 black

Not available

Référence: 832/55

Clamp ring, mixing base

Clamp ring for pitch compensator

Référence: 54/13

Clamp ring pitch compensator 10 mm

On longer rotor shafts the clamp ring for the pitch compensator sits underneath of the centre piece directly on the rotor shaft.Clamp ring for pitch compensator 10 mm Ø, length of the pin 30 mm.

Référence: 79/13

Flybar stainless steel 4 x 560 mm

The length of the flybar itself also plays an important role in the model's flight characteristics: the longer the flybar, the smoother the hover. A longer flybar increases the control deflections. 450 mm length is considered normal, while 510 mm provides more docile handling.

Référence: 702/95

Spring for rotor head Bell 47

 Content of the package2 pieces

Référence: 85/1

Spacer 4 x 6 x 1.5 mm

Spacer 4 x 6 x 1.5 mm, brass Content of the package: 2 pieces

Référence: 704/39

cabezal de rotor de 4 palas 15 mm

Référence: 68/22

Aluminium side frames

Aluminium side frames for swashplate driver 68/20 and 68/50. Content of the package: 2 pieces

Référence: 832/72

Aluminium centre piece, 12 mm

Aluminium centre piece for rotor head 722/72.