O-ring 2.5 x 12 mm, for Elastomer rotor head

Riferimento: 74/5

Anello 3 x 7 mm. tipo morbido

O-ring 3 x 7 mm soft Content of the package: 4 pieces Tip: O-rings always slide with a drop of silicone oil onto the shaft.

Riferimento: 704/39

cabezal de rotor de 4 palas 15 mm

Riferimento: 87/20

Actuating lever

The connection between mixer lever and variable rocker is carried out by an actuating lever, triple ballraced. Content of the package: 2 pieces

Riferimento: 257/45

Rocker kit for Bell UH / Bell 212 T-Rex

Not available

Riferimento: 72/1

Freno rotore ø oltre 2 m.

When you have landed and stopped the engine, the rotor head continues spinning for quite some time until it stops by itself. A rotor brake shortens the time you have to wait. Using light pressure with the flat of your hand on the domed face of the rotor brake you can stop the rotor in a few moments. Pease note: stay in safe distance away from the turning...

Riferimento: 832/75

Thrust washer

Thrust washer for rotor head Content of the package: 2 pieces

Riferimento: 72/18

Rotor head centre piece, rigid

Aluminium centre piece, rigid, for 10 mm main shaft

Riferimento: 74/7

Rotor head dampers for 2 blade FBL systems

Flybarless electronics have now become common. Where they are being used harder damping is required.For these cases Vario is now offering a harder damping of the blade shaft provided by a pretension absorbing element in the centre block.For the adjustment, the outer O-ring position can be selected between "hard" and "soft" flight characteristics.Important...

Riferimento: 79

Flybar stainless steel 4 x 450 mm

The length of the flybar itself also plays an important role in the model's flight characteristics: the longer the flybar, the smoother the hover. A longer flybar increases the control deflections. 450 mm length is considered normal, while 510 mm provides more docile handling.

Riferimento: 76/10

Blade holder, aluminium

Blade holder, aluminium, alone.

Riferimento: 74/14

O-ring 3 x 16 mm soft

O-ring 3 x 16 mm soft Content of the package: 8 pieces Tip: O-rings always slide with a drop of silicone oil onto the shaft.

Riferimento: 80/10

Ponte compensatore di passo

The control bridge actuates the flybar. The servos pass the control commands to the swashplate. The collective pitch compensator connected to the swashplate transfers the movement to the control bridge via the angled pushrods. The flybar accepts the control commands and passes them on to the blade holders and the rotor disc.Control bridge, GRP, for 4 mm ∅...

Riferimento: 76/9

Portapala

Blade holder arm, aluminium. Content of the package: 1 piece.

Riferimento: 10/91

Tubo silicone 8 x 2 x 100 mm

Content of the package: 1 piece

Riferimento: 71/28

Set orecchie e spinotti

Curved link, with pin

Riferimento: 702/90

Aluminium centre piece

Aluminium centre piece for 12 mm Ø main shaft