Tail fin and strut holder

Référence: 860/31

Strebenanschluß-Hülse

Référence: 809/12

M 4 Verschraubung

Référence: 800/36

Bouchon en caoutchouc 14 mm, pin 5x6mm

Rubber plug 14 mmCone 5 x 6 mmContent of the package 6 pieces

Référence: 860/30

CFK-Rohr 8 x 6 x 700 mm

Référence: 830/10

Streben für Benzin-Trainer

Référence: 870/41

Untere Edelstahl-Träger 8 mm

Référence: 870/7

Heckrohrhalter, Alu

Référence: 870/40

Edelstahl-Trägerrohre 8 mm

Référence: 31/7

Inserto de soporte de pluma trasera

Référence: 800/24

Kit empennage, grand

If you fit a large stabiliser to your trainer there is no need for a tail skid. This stabiliser provides the tail rotor blades with enough ground clearance, and offers good flight stability at low airspeeds. There are two versions with different methods of attachment.height 275 mm118 g total weightwith clamp for 20 mm Ø tail booms

Référence: 800/20

Béquille rouge

Tail skids only. Create your own individual colour scheme: e.g. white stabiliser - red skid!

Référence: 310/8

Support de résonateur 70 mm

GRP tuned pipe holders are used to secure the tuned pipe to the tail booms. They are easy to clamp in place. The tail pipe of the tuned pipe should be covered with silicone hose (Order No. 116/8), or with one of the tail pipes (Ord.No. 116/0 or 116/9), so that the heat of the pipe does not damage the holder.Tuned pipe holder, 2-partfor 20 mm ��tail boom

Référence: 260/15

Etrier de patin

Skid strut 8 x 450 mm silver

Référence: 890/5

Kufenauflage

Référence: 800/50

Empennage 3-D en fibre de carbone

When you are attempting high-speed flying in reverse and also certain pirouettes you may find that the helicopter's heading changes due to the influence of the solid vertical stabiliser. That is the basic reason for the development of this special 3-D tail.It is very strong, and its large size removes the need for a tail skid. The stabiliser is...

Référence: 870/8

Winkel für Kreisel