Canopy holder 26 mm

Reference: 260/17

Centre bearing set

 Centre bearing setincluding 2 O-ringsexcluding ballrace

Reference: 830/6

RC-Vorbau

Reference: 860/120

Toothed belt for X-Perience, 3M/606

Toothed belt for X-Perience. Content of the package: 1 piece.

Reference: 800/5

Stabiliser set red

Instead of a horizontal fin (for mounting on the tail boom) the small inset horizontal panel replaces that. The inset fits on top of the stabiliser, outwards opposite of the tail rotor.220 mm high, excl. tail skid3-part, 45 g total weight

Reference: 260/2

Tail fin and strut holder

Tail fin and strut holder XLV.

Reference: 722/39

Support for motor

Support for motor

Reference: 860/11

Heckrohrhalter, 2fach kugelgelagert

Reference: 800/24

Stabiliser set large

If you fit a large stabiliser to your trainer there is no need for a tail skid. This stabiliser provides the tail rotor blades with enough ground clearance, and offers good flight stability at low airspeeds. There are two versions with different methods of attachment.height 275 mm118 g total weightwith clamp for 20 mm Ø tail booms

Reference: 310/8

Tuned pipe holder 2-part

GRP tuned pipe holders are used to secure the tuned pipe to the tail booms. They are easy to clamp in place. The tail pipe of the tuned pipe should be covered with silicone hose (Order No. 116/8), or with one of the tail pipes (Ord.No. 116/0 or 116/9), so that the heat of the pipe does not damage the holder.Tuned pipe holder, 2-partfor 20 mm ��tail boom

Reference: 118/62

Photo and video landing gear

It's a simple matter to clip the still / video camera landing gear underneath any model helicopter, and you're ready to start taking still or video pictures from the air. You will need a little...

Reference: 870/24

Kühlluftschacht X-Treme, 4teilig

Reference: 860/30

CFK-Rohr 8 x 6 x 700 mm

Reference: 800/50

3-D stabiliser, carbon fibre

When you are attempting high-speed flying in reverse and also certain pirouettes you may find that the helicopter's heading changes due to the influence of the solid vertical stabiliser. That is the basic reason for the development of this special 3-D tail.It is very strong, and its large size removes the need for a tail skid. The stabiliser is...

Reference: 809/24

Kühlluftschacht Skyfox, rauchglas

Reference: 107/27

Ball-link curved

 Ball-linkcurvedpack of 6

Reference: 870/4

Querverbinder, GFK