

Ninguna marca
Política de seguridad
Política de envío
Política de devolución
No hay reseñas de clientes en este momento.
Reference: 54/14
The clamp ring below the dome plate secures the rotor shaft inside the mechanics. Pay attention to achieve a safe installation, because the complete model is hanging on this clamp ring! Clamp ring for rotor shaft 12 mm Ø
Reference: 830/66
Set in carbon fiber, complete as illustrated
Reference: 49/55
This slotted connection shaft holds the loop of the 2 mm tail drive wire. Like all other tail drive systems it is necessary to install "play" (approx. 1 mm) for the wire. Yoke connector5 mm diameter shaft
Reference: 61/20
The ballraced 60° bellcrank, for example, is positioned between the horizontal pushrod from the throttle servo and the pushrod running to the barrel arm on the carburettor. When the arm below the ball is vertical the engine is stopped. When the 60° arm is horizontal the engine is at full throttle.In models with overhead tail rotor (e.g. BK 117, BO 105)...
Reference: 132/37
These parts are used in a petrol Fenestron mechanical system for mounting the gearbox, where the rotational speed of the tail drive shaft has to be increased.Pack of 2
Reference: 412/15
For Bell 412, Ord.No. 4125 when using JetCat PHT2 turbine