Inserto de soporte de pluma trasera

Reference: 870/31

Strebenanschluß-Hülse

Reference: 118/62

Photo and video landing gear

It's a simple matter to clip the still / video camera landing gear underneath any model helicopter, and you're ready to start taking still or video pictures from the air. You will need a little...

Reference: 310/8

Tuned pipe holder 2-part

GRP tuned pipe holders are used to secure the tuned pipe to the tail booms. They are easy to clamp in place. The tail pipe of the tuned pipe should be covered with silicone hose (Order No. 116/8), or with one of the tail pipes (Ord.No. 116/0 or 116/9), so that the heat of the pipe does not damage the holder.Tuned pipe holder, 2-partfor 20 mm ��tail boom

Reference: 722/37

Angle bracket

Angle bracket

Reference: 107/26

Chassis brace set for X-Treme

Chassis brace set for X-Treme31-part

Reference: 30/7

Strut set fibra de carbono 8 x 200 mm

Reference: 870/40

Edelstahl-Trägerrohre 8 mm

Reference: 800/25

Stabiliser set large

If you fit a large stabiliser to your trainer there is no need for a tail skid. This stabiliser provides the tail rotor blades with enough ground clearance, and offers good flight stability at low airspeeds. There are two versions with different methods of attachment.275 mm high118 g total weightscrew fitting to tail rotor holder

Reference: 800/37

Canopy holder 26 mm

The required length of the canopy holder is determined by the kind of canopy and the location of its fitting points on the side frames.

Reference: 24/7

Conducto de aire de enfriamiento para foxy

Reference: 7/6

Tube drive nut M 3

 Content of the package4 pieces

Reference: 809/12

M 4 Verschraubung

Reference: 860/11

Heckrohrhalter, 2fach kugelgelagert

Reference: 834/41

Toothed belt, XL/190

Toothed belt for BENZIN Acrobatic.

Reference: 800/36

Rubber plug 14mm, cone 5x6mm.

Rubber plug 14 mmCone 5 x 6 mmContent of the package 6 pieces

Reference: 800/5

Stabiliser set red

Instead of a horizontal fin (for mounting on the tail boom) the small inset horizontal panel replaces that. The inset fits on top of the stabiliser, outwards opposite of the tail rotor.220 mm high, excl. tail skid3-part, 45 g total weight