longitudinal carrier, GFK

Reference: 870/50

Front vertical frame, X-Treme

Not available

Reference: 44/9

Main gear hub

Not available

Reference: 44/52

Gear 52-tooth

Gear 52-tooth GRP The illustration shows a symbol with the number of teeth of the main gear. The number next to the back slash shows the number of teeth for the appropriate clutch and the resulting gear ratio.

Reference: 4/30

90° Nippel mit Zollgewinde

Reference: 44/54

Gear 54-tooth

Gear 54-tooth GRP The illustration shows a symbol with the number of teeth of the main gear. The number next to the back slash shows the number of teeth for the appropriate clutch and the resulting gear ratio.

Reference: 870/2

RC frame, GFK, for X-Treme

Not available

Reference: 809/200

SkyFox side frames with cooling duct

Not available

Reference: 870/6

Gyro plate GFK, X-Treme

Not available

Reference: 871/2

Servo plate CFK for throttle Servo, X-Treme

Not available

Reference: 1006/9

Main gear box with freewheel

If you require a driven tail rotor for auto-rotation, the main gear hub must be fitted with a freewheel; the freewheel on the main rotor shaft then needs to be replaced by a fixed hub mounted on the main rotor shaft.Main gearbox incl. freewheel for driven tail rotor for auto-rotation landings; kit-form. The pinion shaft 41/25 supplied is only suitable for...

Reference: 809/50

SkyFox left side frame

Not available

Reference: 41/25

Pinion shaft 16.5 mm - for AR

The pinion shaft (shaft and integral spur gear) is one link in the transmission which transfers the engine's power to the main rotor.Pinion shaft with 16.5 mm gear depthsolely for the use with the freewheel bell Ord.No. 36/40or with the hub bell Ord.No. 36/45The length of both pinion shafts is ideal for the optional installation of a driven tail rotor for...

Reference: 870/53

Bearing plate, GFK

Not available

Reference: 37/11

Gearbox cover

Gearbox cover for gearbox housing Ord.No. 37/10, alone.

Reference: 1006/10

Main gear box

The main gearbox is responsible for driving the main and tail rotors. To complete the main gearbox you will need to select a gear with the appropriate number of teeth to match your clutch, and also a gearbox connection which mates with your existing tail rotor drive system.Main gearbox, kit-form. The pinion shaft 41/25 supplied is only suitable for use...

Reference: 870/5

Servo frame, GFK, for X-Treme

Pack of 2