Photo and video landing gear

Reference: 860/10

Streben-Set, CFK

Reference: 260/15

Skid strut

Skid strut 8 x 450 mm silver

Reference: 260/17

Centre bearing set

 Centre bearing setincluding 2 O-ringsexcluding ballrace

Reference: 890/5

Kufenauflage

Reference: 800/25

Stabiliser set large

If you fit a large stabiliser to your trainer there is no need for a tail skid. This stabiliser provides the tail rotor blades with enough ground clearance, and offers good flight stability at low airspeeds. There are two versions with different methods of attachment.275 mm high118 g total weightscrew fitting to tail rotor holder

Reference: 870/105

Toothed belt, pitch T5/340

Toothed belt, pitch 5for X-Treme trainer helicoptersWhen replacing a toothed belt please note that different toothed belts are used in X-Treme mechanics and X-Treme trainer helicopters.

Reference: 260/2

Tail fin and strut holder

Tail fin and strut holder XLV.

Reference: 830/6

RC-Vorbau

Reference: 809/12

M 4 Verschraubung

Reference: 7/6

Tube drive nut M 3

 Content of the package4 pieces

Reference: 310/8

Tuned pipe holder 2-part

GRP tuned pipe holders are used to secure the tuned pipe to the tail booms. They are easy to clamp in place. The tail pipe of the tuned pipe should be covered with silicone hose (Order No. 116/8), or with one of the tail pipes (Ord.No. 116/0 or 116/9), so that the heat of the pipe does not damage the holder.Tuned pipe holder, 2-partfor 20 mm ��tail boom

Reference: 800/4

Stabiliser set white

Instead of a horizontal fin (for mounting on the tail boom) the small inset horizontal panel replaces that. The inset fits on top of the stabiliser, outwards opposite of the tail rotor.220 mm high, excl. tail skid3-part, 45 g total weight

Reference: 800/6

Stabiliser set yellow

Instead of a horizontal fin (for mounting on the tail boom) the small inset horizontal panel replaces that. The inset fits on top of the stabiliser, outwards opposite of the tail rotor.220 mm high, excl. tail skid3-part, 45 g total weight

Reference: 860/120

Toothed belt for X-Perience, 3M/606

Toothed belt for X-Perience. Content of the package: 1 piece.

Reference: 870/24

Kühlluftschacht X-Treme, 4teilig

Reference: 810/5

Kufenauflage