Control de Flybar con enlaces

Riferimento: 71/4

Corpo centrale, compensatore di passo

Pitch mixer centre piece, aluminium, 10 mm ∅

Riferimento: 72/40

Rotor head centre piece

Aluminium centre piece for 10 mm main shaft

Riferimento: 74/3

O-ring 1 x 4 mm soft

content of the package: 8 pieces

Riferimento: 78/41

Mixer lever cranked

Mixer lever, content of the package 1 piece.Additionial accessories for the use of mixer levers are either two flanged ballraces or two flanged bushes from Delrin as a low cost alternative. The screwing on the blade holder arm complies with the kind of hole, i.e. it depends on the through hole or on the blind hole. Please note for choosing the screws:...

Riferimento: 832/70

Mixer arms, aluminium

Mixer arms, aluminium Content of the package: 2 pieces

Riferimento: 76/16

GRP blade holder, 5 mm ∅ hole

As demands on helicopters continue to rise, so stronger blade holders are required. In this case a 14 mm blade holder is combined with a 5 mm Ø hole for blade retention, i.e. the matching blade holder screws and self-locking nuts are M5 in size.GRP blade holder with long linkage armfor two-blade rotor heads

Riferimento: 78/40

Set leva miscelatore

Mixer levers are an essential part of every flybar-controlled rotor head. From the swashplate a pushrod runs to the ballraced mixer arm which is screwed to the blade holder arm. The mixer levers transmit the control movement to the flybar via the double ball-link.Additionial accessories for the use of mixer levers are either two flanged ballraces or two...

Riferimento: 74/14

O-ring 3 x 16 mm soft

O-ring 3 x 16 mm soft Content of the package: 8 pieces Tip: O-rings always slide with a drop of silicone oil onto the shaft.

Riferimento: 73/10

Albero porta pale 8 x 110 mm

 Thrust bearing shaft8 Ø x 110 mm

Riferimento: 80/30

Trascinatore

Control bridge 2-part metal, for 5 mm ∅ flybar.

Riferimento: 72/42

CFRP plates for aluminium hub

This rotor head hub with its bonded-in carbon fibre plates is a real head-turner. The plates are simply glued into the existing recesses on both sides. We recommend silicone rubber, Ord.No. 10/11, as adhesive.CFRP plates for aluminium hub matching Ord.No. 832/72pack quantity: 2 plates

Riferimento: 71/27

Spinotti con seeger

Pivot pin with circlipContent of the package 2 pieces

Riferimento: 1005/8

Kit de conversión varillaje directo para JetRanger XL eléctrico

Riferimento: 71/18

Spacer for pitch compensator 2.8 x 5 x 2 mm

 Content of the package2 pieces

Riferimento: 73/15

Albero porta pale 8 x 115,9 mm

 Thrust bearing shaft8 Ø x 115.9 mm

Riferimento: 82/52

Spacer washer for SKS rotor head

Spacer washer for SKS rotor head Content of the package: 2 pieces