Freno de rotor CFRP

Reference: 79/30

Flybar stainless steel 5 x 600 mm

The length of the flybar itself also plays an important role in the model's flight characteristics: the longer the flybar, the smoother the hover. A longer flybar increases the control deflections. 450 mm length is considered normal, while 510 mm provides more docile handling.

Reference: 704/39

cabezal de rotor de 4 palas 15 mm

Reference: 707/3

Rotor head cover for 3-blade head

155 mm diameter

Reference: 703/45

Rotor head linkage for Alouette III

This rotor head linkage is essential for the correct operation of the rotor head of the Alouette III due to its heavy take-off weight.

Reference: 54/18

Clamp ring for 12 mm

Same design as clamp ring 54/13, but for 12 mm Ø main rotor shaft.Clamp ring for pitch compensator 12 mm Ø, length of the pin 40 mm.

Reference: 832/55

Clamp ring, mixing base

Clamp ring for pitch compensator

Reference: 72/5

Rotor brake, GRP

When you have landed and stopped the engine, the rotor head continues spinning for quite some time until it stops by itself. A rotor brake shortens the time you have to wait. Using light pressure with the flat of your hand on the domed face of the rotor brake you can stop the rotor in a few moments.Please note: stay in safe distance away from the turning...

Reference: 722/71

Collective pitch compensator 12 mm

Pitch compensator, complete, for 12 mm Ø main shaft, centre piece aluminium.For use with the rotor head Ord.No. 722/72.

Reference: 80/30

Control bridge 2-part metal, 5 mm

Control bridge 2-part metal, for 5 mm ∅ flybar.

Reference: 78/41

Mixer lever cranked

Mixer lever, content of the package 1 piece.Additionial accessories for the use of mixer levers are either two flanged ballraces or two flanged bushes from Delrin as a low cost alternative. The screwing on the blade holder arm complies with the kind of hole, i.e. it depends on the through hole or on the blind hole. Please note for choosing the screws:...

Reference: 71/55

Collective pitch compensator 12 mm

Pitch compensator, complete, for 12 mm Ø main shaft, centre piece aluminium

Reference: 74/11

O-ring 1,5 x 11 mm soft

O-ring 1,5 x 11 mm soft Content of the package: 8 pieces Tip: O-rings always slide with a drop of silicone oil onto the shaft.

Reference: 76/15

GRP blade holder reinforced

Blade holder, GRP, reinforced

Reference: 707/5

Rotor head cover for 5-blade head

The multi-blade rotor heads of full-size helicopters are generally fitted with protective covers; this applies to the Ecureuil, the Dauphin, the Eurocopter EC 135 and 145, the MD Hughes, etc. Rotor head covers also look good on your model, and we stock them with indentations corresponding to the number of blade grips. The covers are made of CFRP and can...

Reference: 707/6

Rotor head cover for 4-blade head

Not available

Reference: 74/20

O-ring 3 x 11 mm, for CSS rotor head

O-ring 3 x 11 mm for CSS rotor head Content of the package: 2 pieces Tip: O-rings always slide with a drop of silicone oil onto the shaft.