Ninguna marca
Referencia: 92/91
Brida rodamientos autolubricantes 6 x 10 x 3 mm
Política de seguridad
Política de envío
Política de devolución
No hay reseñas de clientes en este momento.
Référence: 755/26
Batteries, receiver etc. are very safe in the front structure if they are packed in a foam sleeve.Many hard landings will cause no damage. The same applies to your electronic units provided that they are cossetted in a shock-absorbing foam sleeve.You just cut off the length you require.Inner diameter: 35 mmFoam rubber sleeve, approx. 250 mm
Référence: 1407
Cables which could chafe somewhere on the model are best run in this flexible spiral tubing – it keeps the cables well protected. It doesn't matter whether there are two or six servo cables, the cable spiral tubing expands round the cables keeping the installation neat. Each pack has 1 m length. black
Référence: 15/4
High current bullet connectors 6 mmincluding heat shrink sleeves
Référence: 1409
The cable holder can be fixed over the eyelet. then wrap the sheathed metal strap around the cable.Length: 32 mmPack of 10
Référence: 9/21
Damping material approx. 60 x 250 mm self-adhesive pad for electronics and installation of tanks
Référence: 1408
A practical method of protecting cables in any model helicopter. This textile-reinforced sleeve protects cables very effectively when they have to be bundled together inside the mechanics; typically servo and extension leads.Length: 1 m
Référence: 25/9
Between fuselage and exhaust tube a heat-reflecting mat avoids melting of the fibreglass. Even in smaller fuselages where conventional silencer systems are close to the inside surface, the heat reflective mat is useful as a heat shield.Heat reflective matheat rejectingsize approx. 300 x 700 mmmat thickness approx. 3 mm
Référence: 809/3
The ideal method of mounting your gyro or your receiver is to use this carbon fibre plate with its reinforced cross-piece.
Référence: 755/31
Self adhesive velcro padsdimensions: 20 x 20 mm
Référence: 809/2
A good method of mounting your gyro or your receiver is to use this aluminium plate.
Référence: 742/42
Cable ties have a versatile use: they fasten fuel pipes in the right position, they fasten your training undercarriage to the skids, they tidy cables and they even hold fuel tanks and batteries. Contents of each pack 10 pieces available in different length 100 mm black 100 mm white 200 mm black 200 mm white 360 mm black
Référence: 15/3
useful for battery packs for electric helicopters
Référence: 10/2
Heat-shrink sleeving is a highly versatile material, and is useful for aerial joints, wire tailskids, and as security for transmitter strap clips. Heat shrink sleeve set 2 mm, 3.1 mm and 5.5 mm Ø, two of each, 25 cm long Tip For absolute water and dust proof protection of patch cables use a larger heat shrink sleeve over the patch cable and fill both...
