O-ring 3.5 x 12 mm hard

Riferimento: 74/20

O-ring 3 x 11 mm, for CSS rotor head

O-ring 3 x 11 mm for CSS rotor head Content of the package: 2 pieces Tip: O-rings always slide with a drop of silicone oil onto the shaft.

Riferimento: 707/3

Rotor head cover for 3-blade head

155 mm diameter

Riferimento: 79/25

Flybar stainless steel 5 x 530 mm

The length of the flybar itself also plays an important role in the model's flight characteristics: the longer the flybar, the smoother the hover. A longer flybar increases the control deflections. 450 mm length is considered normal, while 510 mm provides more docile handling.

Riferimento: 702/91

Rocker for Bell 47 rotor head, silver

Not available

Riferimento: 87/12

Doble bola-link para Delta rotor

Riferimento: 832/72

Aluminium centre piece, 12 mm

Aluminium centre piece for rotor head 722/72.

Riferimento: 72/5

Rotor brake, GRP

When you have landed and stopped the engine, the rotor head continues spinning for quite some time until it stops by itself. A rotor brake shortens the time you have to wait. Using light pressure with the flat of your hand on the domed face of the rotor brake you can stop the rotor in a few moments.Please note: stay in safe distance away from the turning...

Riferimento: 702/76

GRP blade holder, 22 mm blade throat

This blade holder was specially developed for the large Bell 47 G III with a rotor diameter of 2.36 m. It has a 22 mm blade throat and a 6 mm Ø bore for the retaining screw, i.e. the matching blade holder screws and self-locking nuts are M6 in size.

Riferimento: 74/4

O-ring 2 x 4 mm soft

O-ring 2 x 4 mm soft Content of the package: 8 pieces Tip: O-rings always slide with a drop of silicone oil onto the shaft.

Riferimento: 10/81

Tubo silicone 5 x 7 x 100 mm

 Silicone sleeve5 x 7 x 100 mmtransparent

Riferimento: 71/4

Corpo centrale, compensatore di passo

Pitch mixer centre piece, aluminium, 10 mm ∅

Riferimento: 54/13

Clamp ring pitch compensator 10 mm

On longer rotor shafts the clamp ring for the pitch compensator sits underneath of the centre piece directly on the rotor shaft.Clamp ring for pitch compensator 10 mm Ø, length of the pin 30 mm.

Riferimento: 79/30

Asta stabilizzatore 5 x 600 mm

The length of the flybar itself also plays an important role in the model's flight characteristics: the longer the flybar, the smoother the hover. A longer flybar increases the control deflections. 450 mm length is considered normal, while 510 mm provides more docile handling.

Riferimento: 702/96

Inertia weights

set of 2

Riferimento: 76/10

Blade holder, aluminium

Blade holder, aluminium, alone.

Riferimento: 79

Flybar stainless steel 4 x 450 mm

The length of the flybar itself also plays an important role in the model's flight characteristics: the longer the flybar, the smoother the hover. A longer flybar increases the control deflections. 450 mm length is considered normal, while 510 mm provides more docile handling.