Ball-collet with double ball

Riferimento: 71/20

Compensatore di passo, VTR

Pitch compensator, complete, for 10 mm ∅ main shaft, centre piece GRP

Riferimento: 72/18

Rotor head centre piece, rigid

Aluminium centre piece, rigid, for 10 mm main shaft

Riferimento: 72/22

Rotor head centre piece, rigid

Aluminium centre piece, rigid, for 12 mm main shaft

Riferimento: 10/81

Tubo silicone 5 x 7 x 100 mm

 Silicone sleeve5 x 7 x 100 mmtransparent

Riferimento: 68/22

Aluminium side frames

Aluminium side frames for swashplate driver 68/20 and 68/50. Content of the package: 2 pieces

Riferimento: 74/13

O-Ring 2 x 13 mm, soft

O-Ring2 x 13 mmSoftPackage: 8 pieces 

Riferimento: 68/26

Attacco cerniere, dritto

Swashplate link piece, straight. Content of the package: 2 pieces

Riferimento: 72/32

Shaft bearing

Shaft bearing Content of the package: 1 piece

Riferimento: 703/340

Washer for fastening multi-blade head

Not available

Riferimento: 707/5

Rotor head cover for 5-blade head

The multi-blade rotor heads of full-size helicopters are generally fitted with protective covers; this applies to the Ecureuil, the Dauphin, the Eurocopter EC 135 and 145, the MD Hughes, etc. Rotor head covers also look good on your model, and we stock them with indentations corresponding to the number of blade grips. The covers are made of CFRP and can...

Riferimento: 832/69

Connecting elbow, aluminium

Connecting elbow, aluminiumPack of 2

Riferimento: 702/10

Corpo centrale Elastomero

Elastomer 2-blade-centre piece, GRP.

Riferimento: 480/54

Anillo de sujeción plateado con 3 orificios

Riferimento: 832/76

Blade holder, 22 mm

Blade holder, 22 mm, alone

Riferimento: 72/5

Rotor brake, GRP

When you have landed and stopped the engine, the rotor head continues spinning for quite some time until it stops by itself. A rotor brake shortens the time you have to wait. Using light pressure with the flat of your hand on the domed face of the rotor brake you can stop the rotor in a few moments.Please note: stay in safe distance away from the turning...

Riferimento: 76/19

GRP blade holder, 5 mm ∅ hole

As demands on helicopters continue to rise, so stronger blade holders are required. In this case a 14 mm blade holder is combined with a 5 mm Ø hole for blade retention, i.e. the matching blade holder screws and self-locking nuts are M5 in size.GRP blade holder with short linkage armfor multi-blade rotor heads