Rotor blade pouch 2x3 blade max Ø 2100 mm

Reference: 33/27

Rotor blade tie-down large

The rotor blade harness ranks as an essential accessory for full-size helicopters. These items prevent the blades swinging or rocking, and thereby exerting pressure on the rotor shaft. If that were to be allowed, in-flight failures could be attributed to it.Rotor blades set in motion by rising winds could also be damaged by striking obstacles. The rotor...

Reference: 330/18

Gear support for tail drive

Component part for fuselages like Air-Crane, Bell 47 or Lama.Pack of 3

Reference: 74

O-ring 3 x 8 mm hard

O-ring 3 x 8 mm hard Content of the package: 4 pieces Tip: O-rings always slide with a drop of silicone oil onto the shaft.

Reference: 33/3

Rotor blade pouch 3-blade Ø 2500 mm

Reference: 33/4

Rotor bolsa de cuchillas 4 cuchillas Ø 2500 mm

Reference: 33/1

Rotor blade pouch 2-blade Ø 2500 mm

bag length: 120 cmmax. blade width: 9.5 cm

Reference: 97/9

Screw fitting pushrod connector

Screw fixing pushrod connectors can be used on bell-cranks and servo output arms at the tail rotor servo, so that the tail rotor pushrod can quickly be installed, disconnected and adjusted. A further advantage is that a hardened steel pushrod can be used. For one helicopter you need two pushrod connectors.Caution during installation: the barrel of the...

Reference: 18/10

PTFE tube for tail drive shaft

PTFE is used as a bearing for the 2 mm wire tail drive shaft (Ord.No. 17) or as a support guide for the 2 mm piano wire push rod (Ord.No. 21 and 800/12) Length: approx. 740 mm

Reference: 17/2

Steel guide 6.2 x 10 mm

Content of the package 1 piece

Reference: 603/23

Internal damper

 Content of the package2 pieces

Reference: 603/44

Adaptor, aluminium, 36 mm

Component part for fuselages, Ord.No. 6030 or 6031.

Reference: 603/19

Adaptor, tail boom rear, GRP

Component part for fuselages, Ord.No. 6030 or 6031.

Reference: 21/20

Pushrod 1.2 x 1200 mm, steel

Pushrod 1.2 x 1200 mm, steel

Reference: 33/5

Rotorblatttasche 5-Blatt max Ø 2500 mm

Reference: 33/66

Rotor blade pouch 2x3 blade max Ø 2500 mm

Reference: 10/1

Dispenser for UHU plus endfest 300

Using the dispenser allows UHU plus endfest 300 to be allotted exactly, evenly and economically. The special feature of this dispenser is the enclosed mixing nozzle, which mixes the adhesive ready for use.