Servo plug lead

Reference: 340/7

Fuselage centre section for Lama

Component part for fuselage Lama, Ord.No. 3300, 3400, and 3401.

Reference: 330/18

Gear support for tail drive

Component part for fuselages like Air-Crane, Bell 47 or Lama.Pack of 3

Reference: 17/2

Steel guide 6.2 x 10 mm

Content of the package 1 piece

Reference: 333/5

Rotor blade pouch 5-blade Ø 2500 mm

bag length: 120 cmmax. blade width: 9.5 cm

Reference: 33/4

Rotor bolsa de cuchillas 4 cuchillas Ø 2500 mm

Reference: 18

PVC tube 3.2 x 2.2 x 1000 mm, white

PVC tube 3.2 x 2.2 x 1000 mm, white

Reference: 33/2

Rotor blade pouch 2-blade Ø 2100 mm

bag length: 98 cmmax. blade width: 9.5 cm

Reference: 33/1

Rotor blade pouch 2-blade Ø 2500 mm

bag length: 120 cmmax. blade width: 9.5 cm

Reference: 33/28

Rotor blade tie-down

Rotor blade tie-downs are an essential feature of full-size helicopter life. The tie-down protects the blades from swinging, rocking and stretching, and thereby prevents excessive pressure on the rotor shaft. If these measures were not taken the result could easily be in-flight mechanical failure; rotor blades spinning as the wind rises could strike...

Reference: 21

Pushrod 1.5 x 1000 mm, steel

Pushrod 1.5 x 1000 mm, steel

Reference: 18/10

PTFE tube for tail drive shaft

PTFE is used as a bearing for the 2 mm wire tail drive shaft (Ord.No. 17) or as a support guide for the 2 mm piano wire push rod (Ord.No. 21 and 800/12) Length: approx. 740 mm

Reference: 13/21

Magnets for speed regulator

These magnets are suitable for use with all commercial speed regulators. For installation in the mechanics it is advisable the magnets be glued in a clamp ring Ord.No. 54/6, or as in the photo on the internal-tooth gear ring. Pack of 3

Reference: 603/19

Adaptor, tail boom rear, GRP

Component part for fuselages, Ord.No. 6030 or 6031.

Reference: 33/25

Rotor blade support

Any easy solution to the transport problem: The cut-out of this rotor blade support accommodates to the different shapes of tail booms on fuselages.Rotor blade supportfor fuselages, 30 x 270 x 200 mm

Reference: 33/27

Rotor blade tie-down large

The rotor blade harness ranks as an essential accessory for full-size helicopters. These items prevent the blades swinging or rocking, and thereby exerting pressure on the rotor shaft. If that were to be allowed, in-flight failures could be attributed to it.Rotor blades set in motion by rising winds could also be damaged by striking obstacles. The rotor...

Reference: 791/28

Wing brace

The wing brace prevents the wings vibrating; it can be installed in the Cobra, depending on model version.