Ninguna marca
Referencia: 92/91
Brida rodamientos autolubricantes 6 x 10 x 3 mm
Política de seguridad
Política de envío
Política de devolución
No hay reseñas de clientes en este momento.
Référence: 832/69
Connecting elbow, aluminiumPack of 2
Référence: 703/45
This rotor head linkage is essential for the correct operation of the rotor head of the Alouette III due to its heavy take-off weight.
Référence: 82/52
Spacer washer for SKS rotor head Content of the package: 2 pieces
Référence: 832/75
Thrust washer for rotor head Content of the package: 2 pieces
Référence: 702/76
This blade holder was specially developed for the large Bell 47 G III with a rotor diameter of 2.36 m. It has a 22 mm blade throat and a 6 mm Ø bore for the retaining screw, i.e. the matching blade holder screws and self-locking nuts are M6 in size.
Référence: 71/27
Pivot pin with circlipContent of the package 2 pieces
Référence: 72/5
When you have landed and stopped the engine, the rotor head continues spinning for quite some time until it stops by itself. A rotor brake shortens the time you have to wait. Using light pressure with the flat of your hand on the domed face of the rotor brake you can stop the rotor in a few moments.Please note: stay in safe distance away from the turning...
Référence: 832/73
Blade pivot shaft 10 x 187 mm for rotor head 722/72
Référence: 702/90
Aluminium centre piece for 12 mm Ø main shaft
Référence: 10/81
Silicone sleeve5 x 7 x 100 mmtransparent
Référence: 71/56
Pitch mixer centre piece, aluminium, 12 mm Ø
Référence: 79/21
The length of the flybar itself also plays an important role in the model's flight characteristics: the longer the flybar, the smoother the hover. A longer flybar increases the control deflections. 450 mm length is considered normal, while 510 mm provides more docile handling.
Référence: 707/5
The multi-blade rotor heads of full-size helicopters are generally fitted with protective covers; this applies to the Ecureuil, the Dauphin, the Eurocopter EC 135 and 145, the MD Hughes, etc. Rotor head covers also look good on your model, and we stock them with indentations corresponding to the number of blade grips. The covers are made of CFRP and can...
