
Referencia: 92/91
Rodamiento con orejuela de 6 x 10 x 3 mm
Brida rodamientos autolubricantes 6 x 10 x 3 mm
Ninguna marca
Referencia: 92/91
Brida rodamientos autolubricantes 6 x 10 x 3 mm
Política de seguridad
Política de envío
Política de devolución
No hay reseñas de clientes en este momento.
Riferimento: 49/16
If your helicopter accidentally makes ground contact, the claw coupling may disengage, and the cruciform element may be lost. Fitting an annular retaining spring ensures exact alignment of the claw coupling, and prevents the cruciform element slipping out. Retaining springpack of 2
Riferimento: 105/53
Mechanics support plate, aluminium Content of the package: 1 piece
Riferimento: 603/42
Mechanics support, rear, aluminium Content of the package: 2 piece
Riferimento: 49/55
This slotted connection shaft holds the loop of the 2 mm tail drive wire. Like all other tail drive systems it is necessary to install "play" (approx. 1 mm) for the wire. Yoke connector5 mm diameter shaft
Riferimento: 834/55
CFK side frames and base plate for Acrobatic
Riferimento: 105/43
Strut holder, square bar, aluminium Content of the package: 2 piece
Riferimento: 54/9
Below the dome plate you install the clamp ring with the socket on top if no thrust bearing is mounted. The socket supports the clamp ring against the inner ring of the ballrace - otherwise the clamp ring would grind on the outer ring, and affect the function of the ballrace.Clamp ring for rotor shaft, 10 mm diameter
Riferimento: 36/4
The freewheel disc is positioned on the spigot of the main rotor shaft, with the inner flange in contact with the inner ring of the ballrace in the main gearbox. If you install a driven tail rotor for auto-rotation, a second disc is fitted at the underside of the gearbox, to prevent friction of the rotating parts against the outer ring of the ballrace....
Riferimento: 1002/32
If you prefer to mount the tail rotor servo in the mechanics rather than inside the fuselage, this is the accessory you need.