Abgasdeckel Ø 90 mm

Référence: 341/520

Battery housing /Lama

dimensions: 7.76 x 3.4 x 5.3 cm

Référence: 340/6

Marchepied, pour Lama

If you have a mind to continue adding detail fittings to your Lama, you are sure to appreciate this landing gear step which can be fitted to an existing model at any time. The step is made of stainless steel, and is supplied complete with clips, screw fittings and tread material. Entry step, for Lama, pack of 1

Référence: 341/403

Trappes de visite avant Lama 1:4

dimensions: 6 x 8.2 x 0.5 cm2-part

Référence: 341/409

BTP Lama 1: 4

Référence: 134/444

Winch connections 1:4

dimensions:flat: 1.53 x 1.53 x 0.7 cmhigh: 1.29 x 1.29 x 1.14 cmPackage contains: 3x flat + 4x high

Référence: 341/418

Reinforcements for skis Lama 1:4

Référence: 330/2

Turbine factice GFK

The dummy turbine provides the ideal starting point if you wish to install additional scale fittings on your Lama.The dummy turbine is assembled from six separate GRP mouldings, and fits all models with VR-22 mechanics installed.In the turbine-powered version of the Lama the actual turbine is located in this position.GRP dummy turbineLength approx. 490 mm

Référence: 134/460

Telephone de bord 1:4

dimensions: 1.9 x 1.2 x 6.3 cm

Référence: 341/507

Grand reservoir d'huile Lama 1:4

dimensions: 5.15 x 3.62 x 5.1 cm

Référence: 341/429

Panneau de cockpit détaillé pour Lama

Addition to the Cockpit Ord. No. 340/29 to make it look more realistic

Référence: 340/5

Protection contre l'enlisement pour Lama

When full-size helicopters have to land in deep snow, the skids are fitted with "snowboards" to prevent them sinking in.On the model they look really good, and also help the pilot detect the model's orientation in the air.Make your model an eye-catcher and use some rivets for the decoration of the skies."Snowboards" for Lama, 1 pair

Référence: 134/455

Lampe 1:4

dimensions: diameter: 1.1 cm, length: 5.7 cm

Référence: 340/13

Transmission factice

This dummy power unit can be installed on turbine powered helicopters to produce an even more realistic intersection between the turbine and the gearbox.When the imitation rotor brake of the dummy part is pushed over the turbine starter, the rubber connector is spring-loaded in front of the gearbox connection; retaining screws are not required.Dummy power...

Référence: 341/413

Essuie glace 1:4

dimensions: 10.63 x 0.7 x 1.3 cmPack of 2, each 2-part

Référence: 31/34

Kit manches à balai

Les manches à balai et le levier de Pas font partie des équipements de base de chaque cockpit.La version illustrée correspond à ceux utilisés dans l'hélicoptère grandeur Schweizer 300 C....

Référence: 341/445

Pedales llama x2 1: 4