Gehäuse Elektrik Lama 1:4

Riferimento: 341/507

Serbatio olio grande Lama 1/4

dimensions: 5.15 x 3.62 x 5.1 cm

Riferimento: 341/411

Llama estabilización trasera 1: 4

Riferimento: 330/10

Protezione capottina per Lama

This protective sheath provides effective protection to the cabin of your valuable helicopter, and helps to avoid unsightly scratches. It is simply pulled over the cabin and closed with a hook -and-loop fastener.Cabin sheath for Lamamatching the cabins of the models 3300 and 3400

Riferimento: 341/414

Lama 1: 4 luz anticolisión trasera

Riferimento: 340/6

Pedana di salita per Lama

If you have a mind to continue adding detail fittings to your Lama, you are sure to appreciate this landing gear step which can be fitted to an existing model at any time. The step is made of stainless steel, and is supplied complete with clips, screw fittings and tread material. Entry step, for Lama, pack of 1

Riferimento: 341/403

Per Lama, 1:4

dimensions: 6 x 8.2 x 0.5 cm2-part

Riferimento: 341/413

Wiper, 1:4,2

dimensions: 10.63 x 0.7 x 1.3 cmPack of 2, each 2-part

Riferimento: 341/416

Espejo Lama 1: 4

Riferimento: 330/36

Fissaggio magnetico

If you don't want that the doors of the Lama canopy close itself after opening, you use these magnet latches.

Riferimento: 341/424

Kick bar llama 2 partes 1: 4

Riferimento: 1/21

Helmet for pilot William

As you would expect, we can also supply the matching type of GRP helmet for William the Pilot; it is simply pushed into place on his head. If you wish to fit a radio headpiece, you now have plenty of scope for your imagination: a piece of foam rubber, a thin wire mount and a coiled cable are all you need to make this accessory, and the pilot will...

Riferimento: 341/445

Pedales llama x2 1: 4

Riferimento: 330/2

Imitazione turbina

The dummy turbine provides the ideal starting point if you wish to install additional scale fittings on your Lama.The dummy turbine is assembled from six separate GRP mouldings, and fits all models with VR-22 mechanics installed.In the turbine-powered version of the Lama the actual turbine is located in this position.GRP dummy turbineLength approx. 490 mm

Riferimento: 341/412

Ingresso aria turbina Lama 1/4

dimensions: 8 x 3.5 x 4.3 cm

Riferimento: 341/508

Serbatio olio piccolo Lama 1/4

dimensions: 5.45 x 1.66 x 5.36 cm

Riferimento: 341/417

Specchio Grande, Lama 1:4

dimensions: 4 x 5.4 x 1 cm