Electric Box Lama 1:4

Référence: 10/96

Anti-collision light with red housing

Référence: 341/420

Batterie Lama 1:4

dimensions: 3.2 x 5.25 x 7.75 cm

Référence: 330/10

Housse de protection pour Lama

This protective sheath provides effective protection to the cabin of your valuable helicopter, and helps to avoid unsightly scratches. It is simply pulled over the cabin and closed with a hook -and-loop fastener.Cabin sheath for Lamamatching the cabins of the models 3300 and 3400

Référence: 340/5

Protection contre l'enlisement pour Lama

When full-size helicopters have to land in deep snow, the skids are fitted with "snowboards" to prevent them sinking in.On the model they look really good, and also help the pilot detect the model's orientation in the air.Make your model an eye-catcher and use some rivets for the decoration of the skies."Snowboards" for Lama, 1 pair

Référence: 341/36

Panier de transport, 1 pièce

Load basket for Lamalength:410 mmwidth:100 mmheight70 mm

Référence: 330/36

Fixation de portes

If you don't want that the doors of the Lama canopy close itself after opening, you use these magnet latches.

Référence: 341/445

Pedales llama x2 1: 4

Référence: 341/421

Rueda de ventilador Lama 1: 4

Référence: 341/404

Feux de position Lama x2 1:4

dimensions: 4.5 x 3.2 x 1.8 cmPack of 2 (l/r)

Référence: 341/405

Tube pitot Lama 1:4

dimensions: 5.7 x 1.7 x 2.5 cm

Référence: 341/415

Llamada de rescate por radar x2 1: 4

Référence: 330/31

Fenêtre à bulle

Bubble window for Lama Ord.No. 3300 / 3400 / 3401, Rotor ø 2500 mm

Référence: 134/410

Antena superior 1: 4

Référence: 1/21

Casque pour Pilote William 1:4

As you would expect, we can also supply the matching type of GRP helmet for William the Pilot; it is simply pushed into place on his head. If you wish to fit a radio headpiece, you now have plenty of scope for your imagination: a piece of foam rubber, a thin wire mount and a coiled cable are all you need to make this accessory, and the pilot will...

Référence: 341/424

Kick bar llama 2 partes 1: 4

Référence: 340/1

Support de roue pour Lama

The Lama is a large helicopter, and the supplementary wheels which can be attached to the landing gear make it much easier to move the machine into and out of the hangar. However, the wheels are removed prior to flying the model. These wheel holders for our model of the Lama are made of plastic and are simply glued to the 20 mm Ø skid tubes using UHU...