Set de pegatinas X-Treme 3-D

Reference: 10/90

Canopy latch

The canopy retainer set helps to keep your canopies undamaged for a long period. It absorbs movement, such as abrupt shocks in hard landings, and prevents cracks developing in the canopy.Knurled nuts are used to hold the canopy in place, and they do not intent the canopy when tightened.The components of the canopy retainer system are screwed against...

Reference: 830/1

Decal sheet Benzin Trainer

Reference: 260/61

Support for canopy holder XLV

Support for canopy holder XLV.

Reference: 800/39

Sliding cabin holder, alone

Sliding cabin holder, alone.

Reference: 800/40

Quick-release canopy set

One of the main reasons for the popularity of the "trainer" type of model helicopters is their excellent all-round access to the mechanics once the canopy has been removed.The icing on the cake is to fit our quick-release canopy retainers, because then you don't even need to use screws to retain the canopy. The three small openings in the centre and on...

Reference: 871/1

Decal sheet X-Treme

Reference: 830/60

Canopy holder 58 mm

The required length of the canopy holder is determined by the kind of canopy and the location of its fitting points on the side frames.

Reference: 800/43

Metal canopy latch, set of 3

This quick release is ideal for pod and boom canopies of various designs. These latches are made of metal and attaching / detaching the canaopy is very quick. When mounted the canopy is mechanically locked and can not come loose.Pack of 3

Reference: 808/5

Canopy holder 37 mm

The required length of the canopy holder is determined by the kind of canopy and the location of its fitting points on the side frames.

Reference: 260/62

Rear canopy holder XLV

Rear canopy holder XLV.

Reference: 808/3

Canopy holder 26 mm

The required length of the canopy holder is determined by the kind of canopy and the location of its fitting points on the side frames.

Reference: 810/3

Canopy holder 24 mm

The required length of the canopy holder is determined by the kind of canopy and the location of its fitting points on the side frames.

Reference: 810/4

Transverse link 47 mm

The required length of the transverse link is determined by the kind of canopy and the location of its fitting points on the side frames.Pack of 2

Reference: 870/1

Decal sheet X-Treme

Reference: 808/4

Canopy holder 36 mm

The required length of the canopy holder is determined by the kind of canopy and the location of its fitting points on the side frames.

Reference: 800/41

Canopy ball-end bolts M 3

 Content of the package 2 piecesComponent part for the quick-release canopy set Ord.No. 800/40