Referencia: 92/91
Rodamiento con orejuela de 6 x 10 x 3 mm
Brida rodamientos autolubricantes 6 x 10 x 3 mm
Ninguna marca
Referencia: 92/91
Brida rodamientos autolubricantes 6 x 10 x 3 mm
Política de seguridad
Política de envío
Política de devolución
No hay reseñas de clientes en este momento.
Reference: 870/200
For the conversion of a L.H. X-Treme trainer into a R.H. mechanics needed parts are assembled in this set. This set contains all the parts required for the conversion of a L.H. X-Treme trainer into R.H. mechanics.
Reference: 132/37
These parts are used in a petrol Fenestron mechanical system for mounting the gearbox, where the rotational speed of the tail drive shaft has to be increased.Pack of 2
Reference: 36/11
The freewheel hubs are sealed on both sides by brass rings; the rings can also be replaced when necessary (i.e. when the freewheel bearings are replaced).Pack of 2
Reference: 54/9
Below the dome plate you install the clamp ring with the socket on top if no thrust bearing is mounted. The socket supports the clamp ring against the inner ring of the ballrace - otherwise the clamp ring would grind on the outer ring, and affect the function of the ballrace.Clamp ring for rotor shaft, 10 mm diameter
Reference: 105/53
Mechanics support plate, aluminium Content of the package: 1 piece
Reference: 107/14
Chrome-plated brass balls are used to screw onto bell cranks or servo arms for connection to the ball-links of pushrods. The chromium plating prevents premature wear of the ball links.Content of the package: 25 pieces.
Reference: 53
At the top of the mechanics the dome plate supports the rotor shaft with the help of a 10 x 21 x 5 mm or 12 x 21 x 5 mm ballrace. To reduce the load on the ballrace a thrust bearing can also be fitted under the dome plate.
Reference: 802/64
32-tooth clutch belldouble ballracedincluding lining