Set de conectores de alto voltaje

Reference: 10/85

Hook-and-loop tape 30 x 500 mm

Self-adhesive hook-and-loop tape gives good support to batteries, receivers etc. Components which are fastened with it can be put in and out as often as you like. The joins are not damaged in this process. Pilots in the cockpit can be fitted to their seats with a "cushion" made of this tape. blacknormal stick

Reference: 15/4

High current connectors 6 mm

High current bullet connectors 6 mmincluding heat shrink sleeves

Reference: 742/36

Cable clips self-adhesive

Cable clips made of soft aluminium in strips of four. The double-sided sticky tape adheres very well to smooth surfaces, for example on the vertical plates of the side frames. Servo cables can be routed neatly in the clips.Pack of 4

Reference: 1408

Textile cable protection sleeve

A practical method of protecting cables in any model helicopter. This textile-reinforced sleeve protects cables very effectively when they have to be bundled together inside the mechanics; typically servo and extension leads.Length: 1 m

Reference: 1407

Cable spiral tubing

Cables which could chafe somewhere on the model are best run in this flexible spiral tubing – it keeps the cables well protected. It doesn't matter whether there are two or six servo cables, the cable spiral tubing expands round the cables keeping the installation neat. Each pack has 1 m length. black

Reference: 755/31

Adhesive velcro pads 20 x 20 mm

Self adhesive velcro padsdimensions: 20 x 20 mm

Reference: 28/17

Banana plugs

Banana plugs red and black Pack of 2

Reference: 1409

cable clamp

The cable holder can be fixed over the eyelet. then wrap the sheathed metal strap around the cable.Length: 32 mmPack of 10

Reference: 9/21

Damping material

  Damping material approx. 60 x 250 mm self-adhesive pad for electronics and installation of tanks

Reference: 755/29

Elastic velcro for battery attachment

length: 30 cmPack of 2

Reference: 742/38

Doppelseitiges Klebeband 19 mm

Reference: 25/9

Heat reflective mat

Between fuselage and exhaust tube a heat-reflecting mat avoids melting of the fibreglass. Even in smaller fuselages where conventional silencer systems are close to the inside surface, the heat reflective mat is useful as a heat shield.Heat reflective matheat rejectingsize approx. 300 x 700 mmmat thickness approx. 3 mm

Reference: 10/2

Heat shrink sleeve set

Heat-shrink sleeving is a highly versatile material, and is useful for aerial joints, wire tailskids, and as security for transmitter strap clips. Heat shrink sleeve set 2 mm, 3.1 mm and 5.5 mm Ø, two of each, 25 cm long Tip For absolute water and dust proof protection of patch cables use a larger heat shrink sleeve over the patch cable and fill both...

Reference: 3503

RC connector retainer

Extension cable plugs should not loosen themselves or even come apart. The safety clip for RC-plug connections guarantees permanent contact. Pack of 2

Reference: 1406

Cable spiral tubing

Cables which could chafe somewhere on the model are best run in this flexible spiral tubing – it keeps the cables well protected. It doesn't matter whether there are two or six servo cables, the cable spiral tubing expands round the cables keeping the installation neat. Each pack has 1 m length. transparent

Reference: 809/2

Gyro/receiver plate

A good method of mounting your gyro or your receiver is to use this aluminium plate.