RC-Vorbau Sky Fox

Riferimento: 722/39

Supporto per il motore

Support for motor

Riferimento: 870/8

Winkel für Kreisel

Riferimento: 310/8

Supporto per tubi sintonizzato in 2 parti

GRP tuned pipe holders are used to secure the tuned pipe to the tail booms. They are easy to clamp in place. The tail pipe of the tuned pipe should be covered with silicone hose (Order No. 116/8), or with one of the tail pipes (Ord.No. 116/0 or 116/9), so that the heat of the pipe does not damage the holder.Tuned pipe holder, 2-partfor 20 mm ��tail boom

Riferimento: 809/7

Heckrohrhalter 20 mm

Riferimento: 830/10

Streben für Benzin-Trainer

Riferimento: 107/28

Uniball dritti

 Ball-linkstraightpack of 6

Riferimento: 870/31

Strebenanschluß-Hülse

Riferimento: 800/20

Coda slitta rossa

Tail skids only. Create your own individual colour scheme: e.g. white stabiliser - red skid!

Riferimento: 7/6

Dado della trasmissione del tubo M 3

 Content of the package4 pieces

Riferimento: 722/37

Staffa angolare

Angle bracket

Riferimento: 800/25

Stabilizzatore grande

If you fit a large stabiliser to your trainer there is no need for a tail skid. This stabiliser provides the tail rotor blades with enough ground clearance, and offers good flight stability at low airspeeds. There are two versions with different methods of attachment.275 mm high118 g total weightscrew fitting to tail rotor holder

Riferimento: 800/50

Stabilizzare 3-D, fibra di carbonio

When you are attempting high-speed flying in reverse and also certain pirouettes you may find that the helicopter's heading changes due to the influence of the solid vertical stabiliser. That is the basic reason for the development of this special 3-D tail.It is very strong, and its large size removes the need for a tail skid. The stabiliser is...

Riferimento: 860/31

Strebenanschluß-Hülse

Riferimento: 860/11

Heckrohrhalter, 2fach kugelgelagert

Riferimento: 870/30

Streben-Set, CFK

Riferimento: 800/6

Stabilizzatore giallo

Instead of a horizontal fin (for mounting on the tail boom) the small inset horizontal panel replaces that. The inset fits on top of the stabiliser, outwards opposite of the tail rotor.220 mm high, excl. tail skid3-part, 45 g total weight