Einsinkschutz für Lama

Référence: 341/421

Rueda de ventilador Lama 1: 4

Référence: 341/404

Feux de position Lama x2 1:4

dimensions: 4.5 x 3.2 x 1.8 cmPack of 2 (l/r)

Référence: 341/402

Trappe kero Lama N1 1:4

dimensions: 4.3 x 2.5 cm, inner diameter: 1.43 cm

Référence: 341/412

Entrée l'air turbine 1:4

dimensions: 8 x 3.5 x 4.3 cm

Référence: 330/5

Kit accessoires portes Bell 47 G III, Lama

Door fittings for large-scale model helicopters do not differ fundamentally from one type to another. However, the size of these accessories is important if the model is to look convincing, otherwise they will look out of scale.Compare the door handle of the Lama with that of the Alouette II, and the difference is obvious.The door fittings set for the...

Référence: 341/416

Espejo Lama 1: 4

Référence: 341/36

Panier de transport, 1 pièce

Load basket for Lamalength:410 mmwidth:100 mmheight70 mm

Référence: 341/411

Llama estabilización trasera 1: 4

Référence: 30/50

Extincteur, longueur env. 70 mm

Fire extinguishers in the cockpit are mandatory for any scale model helicopter, since the full-size machines are also required to carry them.Our fire extinguisher is available in two different sizes, and it can be mounted in the cockpit in a wide variety of positions.For models up to 2000 mm rotor diameter we recommend the smaller version; the bigger one...

Référence: 341/408

Oil tank small Lama 1:4

dimensions: 6.8 x 1.8 x 6.8 cm

Référence: 341/414

Lama 1: 4 luz anticolisión trasera

Référence: 330/36

Fixation de portes

If you don't want that the doors of the Lama canopy close itself after opening, you use these magnet latches.

Référence: 330/10

Housse de protection pour Lama

This protective sheath provides effective protection to the cabin of your valuable helicopter, and helps to avoid unsightly scratches. It is simply pulled over the cabin and closed with a hook -and-loop fastener.Cabin sheath for Lamamatching the cabins of the models 3300 and 3400

Référence: 340/2

Accessoires maquette pour Lama turbine

The suckering ducts are on the model exactly on the same place as the original ones in position to the turbine on the full-size helicopter.

Référence: 341/509

Lama BTP 1:5

dimensions: main part: 9.5 x 4.95 x 6.4 cm6-part

Référence: 134/444

Winch connections 1:4

dimensions:flat: 1.53 x 1.53 x 0.7 cmhigh: 1.29 x 1.29 x 1.14 cmPackage contains: 3x flat + 4x high