Basculante estabilizador Bell UH / Bell 212 / Bell 47

Reference: 76/18

Blade holder twin blade bolt

Component part for a multi-blade rotor head for 10 mm or 12 mm Ø main shaft.

Reference: 76/19

GRP blade holder, 5 mm ∅ hole

As demands on helicopters continue to rise, so stronger blade holders are required. In this case a 14 mm blade holder is combined with a 5 mm Ø hole for blade retention, i.e. the matching blade holder screws and self-locking nuts are M5 in size.GRP blade holder with short linkage armfor multi-blade rotor heads

Reference: 82/53

Washer 3.5 x 12 x 3 mm, rubber

Washer 3.5 x 12 x 3 mm, rubber Content of the package: 2 pieces

Reference: 76/25

Blade holder, blade grip 18 mm

Not available

Reference: 82/23

Washer for Delta rocker 5 mm

Washer for Delta rocker 5 mm Content of the package: 2 pieces

Reference: 78/40

Mixer lever set

Mixer levers are an essential part of every flybar-controlled rotor head. From the swashplate a pushrod runs to the ballraced mixer arm which is screwed to the blade holder arm. The mixer levers transmit the control movement to the flybar via the double ball-link.Additionial accessories for the use of mixer levers are either two flanged ballraces or two...

Reference: 74/19

O-ring 1.5 x 19 mm soft

O-ring 1.5 x 19 mm soft Content of the package: 8 pieces Tip: O-rings always slide with a drop of silicone oil onto the shaft.

Reference: 74/15

O-ring 2.5 x 12 mm, for Elastomer rotor head

Pack of 4Tip: O-rings always slide with a drop of silicone oil onto the shaft.

Reference: 72/5

Rotor brake, GRP

When you have landed and stopped the engine, the rotor head continues spinning for quite some time until it stops by itself. A rotor brake shortens the time you have to wait. Using light pressure with the flat of your hand on the domed face of the rotor brake you can stop the rotor in a few moments.Please note: stay in safe distance away from the turning...

Reference: 68/22

Aluminium side frames

Aluminium side frames for swashplate driver 68/20 and 68/50. Content of the package: 2 pieces

Reference: 82/51

Bellcrank

Not available

Reference: 87/15

Double ball-link for rotor head

 Double ball-linkpack of 2

Reference: 74/13

O-Ring 2 x 13 mm, soft

O-Ring2 x 13 mmSoftPackage: 8 pieces 

Reference: 72/32

Shaft bearing

Shaft bearing Content of the package: 1 piece

Reference: 87/12

Doble bola-link para Delta rotor

Reference: 74/5

O-ring 3 x 7 mm soft

O-ring 3 x 7 mm soft Content of the package: 4 pieces Tip: O-rings always slide with a drop of silicone oil onto the shaft.