Ninguna marca
Referencia: 92/91
Brida rodamientos autolubricantes 6 x 10 x 3 mm
Motor mount not drilled pack of 2
Política de seguridad
Política de envío
Política de devolución
Motor mount not drilled pack of 2
No hay reseñas de clientes en este momento.
Riferimento: 860/59
These motor supports fit all models and mechanics of the X-Perience series independent from the type of engines.Motor support X-Periencepack of 2
Riferimento: 59/9
Motor mount for electric motors for installation in the model Silence.
Riferimento: 59/0
Spacer washer for motor mount 3,0 x 12 mm pack of 4
Riferimento: 802/59
2-part bottom mount for for the model helicopter Boxer.
Riferimento: 59/3
Factory-drilled motor mounts, already drilled and tapped for M 3 or M 4, are available in pairs (left / right). Avoid interchanging the left hand with the right hand one!1 pairfactory-drilled
Riferimento: 10/51
To protect your engine effectively against dust you should close the exhaust port after unscrewing the manifold with a dust guard cover at once.Dust guard cover pack of 2 42 mm hole spacing
Riferimento: 59/5
Factory-drilled motor mounts, already drilled and tapped for M 3 or M 4, are available in pairs (left / right). Avoid interchanging the left hand with the right hand one!1 pairfactory-drilled
Riferimento: 59/18
For the model X-Perience (Ord.No. 8600) the thicker engine spacers are required.Engine spacer set2 each 0.5 and 1.0 mm
Riferimento: 59/2
Factory-drilled motor mounts, already drilled and tapped for M 3 or M 4, are available in pairs (left / right). Avoid interchanging the left hand with the right hand one!1 pairfactory-drilled
Riferimento: 802/58
Top motor mount for for the model helicopter Boxer.
Riferimento: 10/50
To protect your engine effectively against dust you should close the exhaust port after unscrewing the manifold with a dust guard cover at once.Dust guard cover pack of 2 34 - 35 mm hole spacing
Riferimento: 59/20
To obtain the optimum clearance between clutch pinion and main gear you can use these shim spacers, which are 0.1 and 0.2 mm thick. Simply loosen the engine retaining screws and place the appropriate shim spacer between engine and engine mount; suits all types of engine.Engine spacer set2 each 0.1 mm and 0.2 mm thick
Motor mount not drilled pack of 2
