Ninguna marca
Referencia: 92/91
Brida rodamientos autolubricantes 6 x 10 x 3 mm
Política de seguridad
Política de envío
Política de devolución
No hay reseñas de clientes en este momento.
Référence: 17/10
When a 2 mm steel drive wire is used between main gearbox and tail gearbox the tail rotor might yaw the heli during acrobatics (e.g. turn), because the wire might "wind up". At this moment a small "wind up" will cause a small change of tail rpm, which requires steering corrections.A so-called "rigid" tail drive system gives a more exact drive to the tail...
Référence: 105/14
Stainless steel tube 8.0 mm2-part (462 mm + 1160 mm)
Référence: 17/16
Advanced pilots appreciate the more precise control response of a rigid tail rotor drive system, as provided by a stainless steel drive shaft. Stainless steel tube 6.0 x 0.3 x 950 mm
Référence: 17/7
The use of an articulated centre support in helicopters with extreme high mounted tail booms (e.g. Hughes 500) helps to balance up to 30 mm vertical off-set between mechanics and tail rotor. The centre support is double ballraced and pre-assembled.
Référence: 945/14
Not available
Référence: 17/75
Stainless steel tail rotor drivefor 25 mm Ø tail boomwith 0.8 mm wall thicknesscomplete as shown
Référence: 17/8
Connecting plug for stainless steel tube 8 mm pack of 2
Référence: 17/15
Stainless steel tube 6.0 x 0.3 x 890 mm
Référence: 17/18
Connecting plug for stainless steel tube 5 mm pack of 2
Référence: 17/20
This version of the ballraced tail rotor drive system is designed for installation in full-fuselage models. Power is transmitted by a 6 mm stainless steel drive shaft with a length of 980 mm.This length ensures that the system can be used in virtually all our larger fuselages, provided that the main and tail rotors are fitted with the articulated...
Référence: 603/18
Component part for fuselages, Ord.No. 6030 or 6031.
Référence: 603/17
Component part for fuselages, Ord.No. 6030 or 6031.
Référence: 17/55
Stainless steel drive for installationin models with 40° angle gearboxcomplete as shown
Référence: 17
The 2 mm steel tail rotor shaft has proved its worth for several decades, especially in beginners' models.Drive shaft, steel, 2.0 x 980 mm
Référence: 800/9
PTFE guides in the tail boom provide the necessary "lubrication" for the drive shaft, which eliminates the need to oil the system separately.PTFE guide for 0.8 mm tail boomPack of 3
