Collective pitch compensator 12 mm

Référence: 703/33

3-blade centre piece 12 mm

Component part for a multi-blade rotor head for 12 mm Ø main shaft; see Ord.No. 703/32, 704/32 resp. 705/32.

Référence: 702/79

Flybar stainless steel 5 x 270 mm

Pack of 2

Référence: 703/72

Eje de rodamiento de cuchillas para cabezal de 3 cuchillas

Référence: 72/3

Rotor brake, GRP, red

When you have landed and stopped the engine, the rotor head continues spinning for quite some time until it stops by itself. A rotor brake shortens the time you have to wait. Using light pressure with the flat of your hand on the domed face of the rotor brake you can stop the rotor in a few moments.Please note: stay in safe distance away from the turning...

Référence: 74/15

Joint torique 2,5 x 12 mm, pour tête de rotor en élastomère

Pack of 4Tip: O-rings always slide with a drop of silicone oil onto the shaft.

Référence: 257/45

Rocker kit for Bell UH / Bell 212 T-Rex

Not available

Référence: 74/18

O-ring 2 x 19 mm soft

O-ring 2 x 19 mm soft Content of the package: 8 pieces Tip: O-rings always slide with a drop of silicone oil onto the shaft.

Référence: 82/50

Rocker, aluminium

Rocker, aluminium, for rotor head 702/75, alone.

Référence: 76/19

GRP blade holder, 5 mm ∅ hole

As demands on helicopters continue to rise, so stronger blade holders are required. In this case a 14 mm blade holder is combined with a 5 mm Ø hole for blade retention, i.e. the matching blade holder screws and self-locking nuts are M5 in size.GRP blade holder with short linkage armfor multi-blade rotor heads

Référence: 832/87

90 degree link

A 90° twisted double ball-link connect the mixer lever to the ball collet on the flybar, suitable for the rotor head 722/72.Content of the package: 2 pieces

Référence: 91/67

Heat shrink for paddles

Heat shrinkapprox. 0.5 m, alone

Référence: 71/4

Pièce centrale en alu Ø 10 mm

Pitch mixer centre piece, aluminium, 10 mm ∅

Référence: 72/1

Frein rotor en CFK

When you have landed and stopped the engine, the rotor head continues spinning for quite some time until it stops by itself. A rotor brake shortens the time you have to wait. Using light pressure with the flat of your hand on the domed face of the rotor brake you can stop the rotor in a few moments. Pease note: stay in safe distance away from the turning...

Référence: 86/10

Ball collet 5 mm

Ball collets provide the fixation of double ball-links on the flybar, in order to settle the essential distance to the rocker.Ball collet 5 mm Ø, pack of 2, chrome-plated.

Référence: 86

Ball collet 4 mm

Ball collets provide the fixation of double ball-links on the flybar, in order to settle the essential distance to the rocker. Ball collet 4 mm Ø, pack of 2, chrome-plated.

Référence: 702/95

Spring for rotor head Bell 47

 Content of the package2 pieces