Ninguna marca
Referencia: 92/91
Brida rodamientos autolubricantes 6 x 10 x 3 mm
Política de seguridad
Política de envío
Política de devolución
No hay reseñas de clientes en este momento.
Référence: 74/14
O-ring 3 x 16 mm soft Content of the package: 8 pieces Tip: O-rings always slide with a drop of silicone oil onto the shaft.
Référence: 79/25
The length of the flybar itself also plays an important role in the model's flight characteristics: the longer the flybar, the smoother the hover. A longer flybar increases the control deflections. 450 mm length is considered normal, while 510 mm provides more docile handling.
Référence: 71/4
Pitch mixer centre piece, aluminium, 10 mm ∅
Référence: 72/22
Aluminium centre piece, rigid, for 12 mm main shaft
Référence: 73/20
Thrust bearing shaft "tubular"27.8 g, 8 mm Ø, 101 mm longonly for Electro rotor head and in use with the model helicopter Silence!
Référence: 76/8
Ballrace spacer, steel Content of the package: 1 piece.
Référence: 832/47
O-ring 5 x 9 mm Content of the package: 2 pieces Tip: O-rings always slide with a drop of silicone oil onto the shaft.
Référence: 71/27
Pivot pin with circlipContent of the package 2 pieces
Référence: 76/16
As demands on helicopters continue to rise, so stronger blade holders are required. In this case a 14 mm blade holder is combined with a 5 mm Ø hole for blade retention, i.e. the matching blade holder screws and self-locking nuts are M5 in size.GRP blade holder with long linkage armfor two-blade rotor heads
Référence: 832/70
Mixer arms, aluminium Content of the package: 2 pieces
Référence: 78/40
Mixer levers are an essential part of every flybar-controlled rotor head. From the swashplate a pushrod runs to the ballraced mixer arm which is screwed to the blade holder arm. The mixer levers transmit the control movement to the flybar via the double ball-link.Additionial accessories for the use of mixer levers are either two flanged ballraces or two...
Référence: 72/1
When you have landed and stopped the engine, the rotor head continues spinning for quite some time until it stops by itself. A rotor brake shortens the time you have to wait. Using light pressure with the flat of your hand on the domed face of the rotor brake you can stop the rotor in a few moments. Pease note: stay in safe distance away from the turning...
Référence: 87/21
Washer for actuator arm Content of the package: 2 pieces
