Tiranta para motor

Reference: 870/4

Querverbinder, GFK

Reference: 860/11

Heckrohrhalter, 2fach kugelgelagert

Reference: 860/53

Domplatte, Alu

Reference: 800/5

Stabiliser set red

Instead of a horizontal fin (for mounting on the tail boom) the small inset horizontal panel replaces that. The inset fits on top of the stabiliser, outwards opposite of the tail rotor.220 mm high, excl. tail skid3-part, 45 g total weight

Reference: 260/15

Skid strut

Skid strut 8 x 450 mm silver

Reference: 126/2

Skid reinforcement, carbon fibre

Not available

Reference: 310/8

Tuned pipe holder 2-part

GRP tuned pipe holders are used to secure the tuned pipe to the tail booms. They are easy to clamp in place. The tail pipe of the tuned pipe should be covered with silicone hose (Order No. 116/8), or with one of the tail pipes (Ord.No. 116/0 or 116/9), so that the heat of the pipe does not damage the holder.Tuned pipe holder, 2-partfor 20 mm ��tail boom

Reference: 870/105

Toothed belt, pitch T5/340

Toothed belt, pitch 5for X-Treme trainer helicoptersWhen replacing a toothed belt please note that different toothed belts are used in X-Treme mechanics and X-Treme trainer helicopters.

Reference: 800/22

Tail skid black

Tail skids only. Create your own individual colour scheme: e.g. white stabiliser - red skid!

Reference: 802/24

Kühlluftschacht Boxer

Reference: 260/17

Centre bearing set

 Centre bearing setincluding 2 O-ringsexcluding ballrace

Reference: 800/50

3-D stabiliser, carbon fibre

When you are attempting high-speed flying in reverse and also certain pirouettes you may find that the helicopter's heading changes due to the influence of the solid vertical stabiliser. That is the basic reason for the development of this special 3-D tail.It is very strong, and its large size removes the need for a tail skid. The stabiliser is...

Reference: 870/31

Strebenanschluß-Hülse

Reference: 30/7

Strut set fibra de carbono 8 x 200 mm

Reference: 870/8

Winkel für Kreisel

Reference: 800/37

Canopy holder 26 mm

The required length of the canopy holder is determined by the kind of canopy and the location of its fitting points on the side frames.