Ninguna marca
Referencia: 92/91
Brida rodamientos autolubricantes 6 x 10 x 3 mm
Política de seguridad
Política de envío
Política de devolución
No hay reseñas de clientes en este momento.
Riferimento: 26/34
Fuel tubing is required to withstand many kinds of thermal and chemical stress, i.e. it has to be resistant to petrol and kerosene whilst maintaining maximum flexibility. However, it must also be possible to fix the tubing reliably to tubes and nipples; the more valuable the model, the more important it becomes to fix the fuel tubing with absolute...
Riferimento: 830/26
Tank 540 ml, petrol-resistantincluding the requested accessories for installation in a Benzin-Trainer or in a petrol mechanics.The CofG of a model helicopter should only be checked with an empty fuel tank.During the flight the fuel is situated in a place where the additional weight does not have an adverse effect. If you set the CofG with a full fuel...
Riferimento: 791/26
Kerosene Tank 1.5 l, GRP, with accessories, for Cobra with Turbine
Riferimento: 116/5
Content of the packag: 1 piececomplete as shown
Riferimento: 830/83-50
Fuel tubing for petrolapprox. 50 mtransparentFuel tubing inevitably suffers from the effects of ageing. Always replace brittle tubing before it gives problems!
Riferimento: 3740
Any turbine-powered model has to carry a very large quantity of fuel, and this in turn calls for a fuel station of ample volume.The VARIO filler station has a capacity of 10 litres and is ideal for flying sessions.The fueltank is filled and drained using a practical geared pump, which is permanently mounted on the fuel container.
Riferimento: 26/60
Aramid is a fibre that is used in motor racing. The tanks have an even surface inside and rough on the outside.These fuel tanks are all pressure tested to make sure that they are 100% leak-proof when they arrive at your workshop.When ordering, one tank is supplied.When mounting the lid, please fix the screws cross-wise using blue loctite until you have...
Riferimento: 26/50
Aramid is a fibre that is used in motor racing. The tanks have an even surface inside and rough on the outside. These fuel tanks are all pressure tested to make sure that they are 100% leak-proof when they arrive at your workshop. They fit in every fuselage, that would normally use the plastic tank Ord.No. 26/5 for. For example, this Aramid tank is...
Riferimento: 3720
This refuelling station for petrol helicopters consists of a petrol-proof container of 3 litres capacity, a hand-pump for filling and emptying, fittings and filler hose.
