Marcas

Ninguna marca

Referencia: 060

Bulon 3.5 mm - M 2.0 x 5.0

Reseña(s): 0

Estos pernos de punta esférica ofrecen una conexión óptima entre un brazo de salida de servo GRP y la varilla de empuje a la mecánica. Debajo del brazo de salida, bloquea el perno de bola con una tuerca hexagonal M 2. Para brazos de salida de aluminio, utiliza pernos de punta esférica. 060/7 y fluido de bloqueo de hilo.

Precio 13,80 €
Más
En venta bajo pedido
Los productos más vendidos

Conector para gancho pc 1:4

134/444
Valoración 
Winch conexiones x18 01:04
16,30 €
Impuestos incluidos
Cantidad
En venta bajo pedido

 

Política de seguridad

 

Política de envío

 

Política de devolución

Descripción
Winch conexiones x18 01:04
Detalles del producto
134/444
Reseñas

No hay reseñas de clientes en este momento.

Escriba su propia reseña

Conector para gancho pc 1:4

Conector para gancho pc 1:4

Winch conexiones x18 01:04
Escriba su propia reseña
16 altri prodotti della stessa categoria:

Riferimento: 330/2

Imitazione turbina

Recensioni: 0

The dummy turbine provides the ideal starting point if you wish to install additional scale fittings on your Lama.The dummy turbine is assembled from six separate GRP mouldings, and fits all models with VR-22 mechanics installed.In the turbine-powered version of the Lama the actual turbine is located in this position.GRP dummy turbineLength approx. 490 mm

Prezzo 106,80 €
Più
In vendita su richiesta

Riferimento: 30/50

Estintore, lunghezza ca. 70mm

Recensioni: 0

Fire extinguishers in the cockpit are mandatory for any scale model helicopter, since the full-size machines are also required to carry them.Our fire extinguisher is available in two different sizes, and it can be mounted in the cockpit in a wide variety of positions.For models up to 2000 mm rotor diameter we recommend the smaller version; the bigger one...

Prezzo 21,50 €
Più
In vendita su richiesta

Riferimento: 330/5

Set accessori portelli per Bell 47 G III, Lama

Recensioni: 0

Door fittings for large-scale model helicopters do not differ fundamentally from one type to another. However, the size of these accessories is important if the model is to look convincing, otherwise they will look out of scale.Compare the door handle of the Lama with that of the Alouette II, and the difference is obvious.The door fittings set for the...

Prezzo 34,20 €
Più
In vendita su richiesta

Riferimento: 341/405

Pitot 41:4

Recensioni: 0

dimensions: 5.7 x 1.7 x 2.5 cm

Prezzo 16,30 €
Più
In vendita su richiesta

Riferimento: 340/1

Supporti ruota per Lama

Recensioni: 0

The Lama is a large helicopter, and the supplementary wheels which can be attached to the landing gear make it much easier to move the machine into and out of the hangar. However, the wheels are removed prior to flying the model. These wheel holders for our model of the Lama are made of plastic and are simply glued to the 20 mm Ø skid tubes using UHU...

Prezzo 33,50 €
Più
In vendita su richiesta